☰

Repair Tips




AIWA
BEKO
CCE
CINERAL
DAEWOO
FUNAI
GRADIENTE
GRUNDIG
HITACHI
ITT
JVC
LG
MITSUBISHI
PANASONIC
PHILCO
PHILIPS
PIONEER
RCA
SAMSUNG
SANYO
SHARP
SONY
THOMSON
TOSHIBA
VESTEL


Search:
Results: 88058
Make Model Symptom Problem Solution By
SAMSUNG LT24A550
Sem of a video component Female connector on the signal board when removing the plug, it bends inside the connector. Just untwist it.
SAMSUNG LN32B550K1V
Turn on and off Rp803, 804, 809, 810 and 811 open
SAMSUNG 40D5000PG
Doesn't turn off Replaced the power supply board.
SAMSUNG VáRIOS
With plot without image Clean change lvds cable.
PHILIPS 55PFL7007G/78
With the letter "c" or "cf" on the screen With the TV on, press volume - for 5 seconds and then channel - for 5 seconds!
PHILIPS 46PFL3008D
When plugged in, it turns on, the Philips logo appears and then turns off and repeats Update
PHILIPS 46PFL3008
Turns on the Philips logo and then turns off and repeats Update
PHILIPS 42PFL8606D
Just the Philips logo and then it turns off Reset
PHILIPS 42PFL4908G
Doesn't work. stand-by LED off. Mainboard, nand-flash data corrupted.
PHILIPS 42PFL3008D
When you turn it on for the first time, it turns on and off quickly, then it doesn't turn on again. Resolder memory u402 from the main board, or remove it and put it back in
PHILIPS 40PFL5606
Turns on the screen and then turns off Poor contact in the LED connectors
PHILIPS 40PFL5605D
Inoperative. in the zd 905 diode it oscillates between 11 and 20v BS260 diode, with slight leakage, you can put two SB360 in place
PHILIPS 39PFL4707G
It would turn off by itself, sometimes the sound would disappear, it would creak before turning off. completely crazy. Update the software
PHILIPS 39PFL4508G
Doesn't start. sometimes it even turns on Pin 4 of the rt8288a ci raised and placed a 100nf capacitor on pin 3
PHILIPS 39PFL3008D
Turns on, the backlight turns on, but tsound is no image. power supply voltages (715g6050-p02) normal. Ic up1 (cm501). In some cases, heating the ci with hot air solves the problem.
PHILIPS 32PFL5606D/78
Does not come out of standby Corrupted memory data. on pin 6 of the 7702 memory, that is, ground pin 6 of the memory. see note.
PHILIPS 32PFL5606D/78
Doesn't start. with only 3.3v present, the other voltages are deactivated. Ver 1m20 e 1d38
PHILIPS 32PFL5606D/78
Sometimes it turns on and works for about 30 seconds, that's when it turns on. Pci principal (bga?).
PHILIPS 32PFL5605D
Doesn't start Activate sdm mode and see if it will turn on normally. If so, check the options
PHILIPS 32PFL4017G/78
It turned on but it was stuck on the HDMI, but tsound are cases wsound it gets stuck on the channel Update the software