Repair Tips
Search:
Results: 88063
Results: 88063
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
CCE |
CW3201 D3201
|
Does not turn on the power supply LED lamps blinks 5 times. | Q9 with leak | Swap the q9 and q8 | eddey alves |
LG |
42LC4R
|
Does not turn on - no standby | R508 2r2 open - power supply only had a voltage of 57v | Replaced 2r2 resistor r508 | HERMES |
PHILCO |
PTV32E21
|
Usb dando 10v | Responsible circuit u1p4 (mp1653), faulty fb circuit, usually the responsible 1kΩ smd resistor r4p15, or r4p13 51kΩ, also test r4p14 33k, in my case it was only r4p15 1k | lucian oliveira 61991271532 DIGITAL TECH | |
LG |
22MA33N-PS
|
This TV came to me when it turned on normally, but the audio gradually dropped until it disappeared. When I pressed the mute button repeatedly the audio came back on and 5 to 10 minutes later it disappeared again. | In my case it was the external power supply with low capacitance capacitors. Either you change the external power supply or repair it yourself. Good luck! | (D.S.E.Eletronica) | |
SAMSUNG |
PL-50P5H
|
No image | Check 4 diodes na y-sus zd5016, zd5017, zd5023, zd5024 | ibramo | |
SONY |
KLV-37NL14A
|
Error code 6 blinks (backlight) | Check inverter_error line capacitors (3v3), look at q4014 | Lexus | |
LG |
50PB560B
|
Image disappears after 10 to 15 minutes | Check c445 | Arnaldo Murta | |
AOC |
LE32H1461
LE32 |
It doesn't turn on, it just stays on, the red LED is on, is the power supply voltage normal? | Some LEDs are burnt or shorted, just change them and it will be back to normal. | Enoque Dantas | |
SEMP |
TV 2070E
|
TV with open vertical. but with intense brightness in the center of the screen in the horizontal direction (the same as when the vertical is completely closed) and with open horizontal lines at the top of the screen (stretched vertical). | 22k r325 altered for 61k non-vertical circuit. | Ademir tc | |
MAGNAVOX |
MAS55
|
Doesn't read cds | Check central sprinter engine and flat connection cable | Matias ERP | |
SAMSUNG |
SCM5550
|
No sound at output | Rd6 e rd1 | Matias ERP | |
LENOXX |
MC247
|
Does not connect cd | Check ci9528 and pci cd | Matias ERP | |
PHILCO |
CPH06M
|
When turning on the power key, it blinks once | Check c704, 708 and 712. | Matias ERP | |
LG |
FFH-V386
|
No audio | 12v missing in voltage regulator ic705, q311 (2sa1273) short | Replace q311 | Matias ERP |
PHILCO |
B481
|
Low sound | Check/replace all electrolytic capacitors | Matias ERP | |
PHILCO |
B481
|
I'm sound | Check swap d205 and d206 | Matias ERP | |
TCL |
L32S4900
|
No image, sound ok | Ceramic capacitor shorted on the screen board | Matias ERP | |
LG |
M275WV
|
After some time on, the sound disappears | 2 capacitors | I replaced 2 47/16v capacitors c712 and c713 I put 47/25v | XANDARE |
SEMP TOSHIBA |
LC3246WDA
|
Turns on and off, backlight flashes, backlight defect, image turns on and off. | Defective lamp connector, oxidized, defective lamp connector, burnt connector | Remove screen to repair | Maike Eletronica Sorriso |
SOM PHILCO |
PB500BT
|
The device makes a humming sound, a constant noise without sound coming out. | We just need to change the 5-vot regulator, ok, the dc 7805 only has one on the board. | Galileu Rocha |