Repair Tips

Search:
Results: 87715

Make	Model	Symptom	Problem
SONY	KX2501A	Set dead, replaced c666 and d658 (add 4700pf across d658)	Should d658 short r675 opens. no 16v to ic 651 allowing power supply to produce 240v on 140v line. blowing out c666.
SONY	XM55	Part number	Need part number for c302 (2200uf 16v). part supplied bynpc is too big to fit in place of this cap. -hq comments: cap's part number is 1-123-566-00. the part is availablefrom npc.
SONY	SL5200	Intermittent eject out of a selected function	Unit would intermittently drop out of the function selectedand eject the tape. found that taping on unit would cause the symptoms.
SONY	SL2500	Drop out of function is special effects mode	After 15 mins on, unit would go into stop mode when specialeffects was selected.
SONY	XR20	Mute problem - intermittent	S802 (mute sw) not operating with every cycle of eject. lub-ing did not help. audio on tape remained dead when tape was inserted. -hq comments: the problem seems to be caused by s802 according to yourreport. however, we have received similar problems
SONY	ICF2001	Frequency image on 79.70 mhz	On icf-2002 on 79.70mhz it is picking up 101.00 mhz and wecompared to icf-7600d which is an european model but it is an identicalunit and it is doing the same thing. is there any solution for these? -hq comments: did you try sens low? if the fm101.1mh
SONY	BMCJ888U	Repair procedure	We have a betamovie signal converter jig bmcj-888u that hasfailed. please advise how we are to proceed. -hq comments: we are sending a copy of the draft for the bmcj-888u fieldservice alignment manual. the manual contains a circuit description,electri
SONY	SL2000	No battery charge from tt	No battery charge from tt. unit was burning d811 on ma-1 brdand blowing fuse f801 in sl. found q651 and ic681 defective. unit wouldnow charge properly, but would not shut off charging ckt when batterythermal switch opened. d824 on ma-1 brd in sl was
SONY	CDP400	Disk turns backward at maximum speed	Disk turned backward at maximum speed as soon as turning onthe power sw. there was no 1/4 rfck from ic503 at pin 27. 8.64mhz clockwas good, so i replaced ic503. i also replaced ic505, because lrck signalwas very low. but they did not cure the problem
SONY	D5	Noise in audio	Only noise was heard in audio.
SONY	KV2649R	No display intermittently, replaced display tube	Intermittent channel indication.
SONY	KV1952RX	Snowy picture, replace vhf tuner	This unit produced a snowy picture, the problem being causedby a defective tuner block. we have had reports of a few of these tunersfailing after only a couple of months usage.
SONY	FD30A	Poor horizontal and vertical linearity, readjusted rv851	This unit displayed poor linearity - both horiz. and vert.we found rv851 (keystone adj) misadjusted, yoke positioning incorrect andthe yoke rings set incorrectly.
SONY	FD30A	No picture, broken solder joint at r807	This unit had sound but no picture. we found a broken solderjoint at r807. this resulted in no focus voltage.
SONY	KV2680R	P/n inquiry for crt, 8-735-453-05 sub to 8-735-453-05	P/n for kv-2681 crt is incorrect. -hq comments: the part # in s/m 8-735-453-05 is correct and correspondsto a67jhg01x type crt. in the near future, it will be supplied as areplacement part in sets specifying this crt.part number landin
SONY	KV2670R	Dark picture, shorted c-527 and open r-526	No y signal, only chroma. found c527 shorted which causedr526 to burn up.
SONY	KV2665	Dead, h out q-504, reg ic-601 and f-602	H. output shorted and took out regulator and fuse.
SONY	KV2657R	High voltage interference	Interference with other sets. high voltage arcing because oneside of c867 on the p board was not soldered. it caused interference withother sets in customer's home.
SONY	KV2654R	Dark picture, replace c531 and r541	Picture is dark during normal transmission on all channels.
SONY	KV2649R	No display light, resoldered jumper	Display did not lite at all. lower channels did not comeon all the time (int). higher channels worked fine, picture was good.found no hp going to t001 (hpt) on mt board.