Repair Tips
Search:
Results: 87709
Results: 87709
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
KP5040
|
Dead, replaced cx171, q5521, q5522 | Set would not turn on. servicer found cx171 defective whichis believed to have caused q5521 and q5522 to short, fuse found defective. | ||
| SONY |
KV2145R
|
Set locks on ch 88, replaced ch indicator nd3101 | Set was locked onto channel 88, unable to clear or change.found pulse out of ic001 on mf board loaded down. traced problem tochannel indicator display nd3101 on ta board. pin 3 on display isshorting to something inside display loading down pin 40 on ic | ||
| SONY |
KV2141R
|
No picture, leaky d511 zener | Unit completely out of horizontal frequency. at pin 8 ofic501 the dc voltage reads 4v instead of 10v. trouble traced back toleaky d511 (rd15e). | ||
| SONY |
KV1945RS
|
Picture distortion, replaced ic501, cx-557 | About the top 10 scan lines were stretch, very hard to detectbut customer complained. vertical output waveform could see ringing,apparently leakage in the ic from horizontal. | ||
| SONY |
KV1921
|
Shut down | Unit shuts dowm erratically. this problem confused theservicer because the original problem was a shorted damper. when ac wasapplied, the unit ran fine up to about 90v ac in then suddenly guit.by using light bulb technique we located q510 breaking down | ||
| SONY |
KV1913
|
No sound | No sound, momentary raster. found q206 and q205 leaky whichdrags the 135 b+ low (70v). | ||
| SONY |
KV1913
|
No vhf low | No low (2-6) channels. could not get high (7-13) band toturn off. found d101 leaky. | ||
| SONY |
KV1910
|
Faint retrace lines on specific channel only | Faint retrace lines only on channel 7. this problem appearedonly when the set was turned to cable 7. it was observed that thevertical sync pulse was compressed on this channel. this resulted in5-6 retrace lines appearing at top of screen. linearity w | ||
| SONY |
KV1207
|
Picture noise | Vertical bars across screen, excess ringing off 190v line offlyback. c540 was missing from circuit. | ||
| SONY |
KV1207
|
No low vhf | No low vhf channels, voltage on q102 remains high regardlessof band switch position. found d059 diode on m4 board leaky. | ||
| SONY |
KV9400
|
Set would lock on one ch | Could not change channels. checked the 33 volt line and foundonly 5 volts. traced to a leaky q18 transistor. | ||
| SONY |
KV3000
|
Intermittent loss of red color | Customer complained of intermittent loss of red in the color.servicer found bad connection at base of q1344 on the b board. | ||
| SONY |
KV2648R
|
Shut down, replace ic601 and others | Shut down. indicator light comes on momentarily after turnon. | ||
| SONY |
KV2602
|
Dead, replaced q601, d501, b rect, etc | Set dead. no sound, no picture. found defective the follow-ing parts: bridge rect. power module, q601 transistor, d501 zener diode,and 5 amp fuse. | ||
| SONY |
KV1946R
|
Dead, replace q901 and q602 | No sound - no picture. found q901 and q602 shorted. | ||
| SONY |
KV1945RS
|
Shut down, solder splash | Immediate shut down after turn on - less than 1/4 second.dealer suspected shut down circuit or power supply but could not evenpower on oscillator. all sweep voltages checked with meter showed 0Ωat 15v line. 15v line on md board shorted to ground. | ||
| SONY |
KV1945R
|
Picture distortion, replaced hlc | Complaint about horiz. linearity specifically when writingtransversed screen. replaced hlc with p/n 1-459-136 (hlc from 1930r).problem resolved. expect inductance of hlc (1-459-316) too low. pleasesupply definite fix - have had 3 complaints to date. | ||
| SONY |
KV1923
|
Sound distortion, replaced d2006 | When set was first powered up, volume was maximum and couldnot be lowered. unit was turned off and restarted with no sound now atall. checking output of a/d convertor, tns3701bns, found no pwm signal.measured standby supply voltage, pin 8, with power o | ||
| SONY |
KV1722
|
Set fails after a few days, replaced r569 | Intermittently this unit would fail after servicing for astart circuit problem anywhere from one week to two months later. theunit had been in 7 times in the last 6 months. after running for aconsiderable time under a heat lamp the voltage at the colle | ||
| SONY |
KV1207
|
Poor vertical | Vc amp leaky. repaired by replacement q101, 2sc1815 withreplacement 2sc1364. unit was ok for 6 weeks, then q101 failed again insame way. replaced and checked circuit. found no reason for failure.perhaps static problem. enclosed you will find the ori |