Repair Tips
Search:
Results: 88103
Results: 88103
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SEMP |
TV1454
|
It takes a while for the sound to come | C603 with low capacitance | Replace of the same | ws eletronica |
| PANASONIC |
TC 21FX32L
|
With sound characters and no image or no contrast | Rakh D Sakh, Ak | Replace | Eletrônica Mauro Mascarenha - Parazinho Ceara - Tel : (88)981422821 |
| PHILCO |
TP-1454
|
Does not turn on the LED is off and tsound are zero volts on the secondary. | Tsound is no power supply on the ic901. | Replace r909 | Eletrônica Daniel Fone: 43-991586898 |
| CCE |
HPS2073
|
Does not turn on blinking stand by led | Replace c831 1000uf/16v | aelson | |
| CINERAL |
29P CIN-0507
|
Has sound but no image | Open resistor 6.8k position on board r432 | Replace with new | <small> |
| LG |
CP-14J52A
|
Did not tune channels | Low voltage at 30v | Replace c103 10μF/50v | Eletrônica maron |
| SAMSUNG |
CL29Z43MQ
|
LED turns on and off when plugged in for 1 second | Dz807 open | Replace | ELETRONEUBERT Plmeirândia MA |
| PHILIPS |
42PFL3604
|
Turns on and after 3 seconds it disables the invert dark screen on one side the normal sound continues | Good inverter transformer reference values t903 and 904 in 18.1Ω / l= 150 mh out 1.1Ω / l6.07 mh, tested with esr02 pro | Changing the replaced traffic! | BRUSKE |
| PANASONIC |
TC-21FX30L
|
Turns on and then turns off, doesn't turn on again, and the LED blinks. | Ic801 strw6754 can put strw6753 . | guinga sdia goias | |
| LG |
32LB3RS
LP70A |
Hissing sound at low volume, especially on hdmi | Several leaky capacitors, but the 100mf c1112 is the one causing the problem. It's on the left edge of the board, next to the memories. | Capacitor replaced and pci cleaning | André |
| TOSHIBA |
TV2159OFS
U19 |
It turns on without sound, and when it turns off it's going to turn on, it doesn't turn on, in RF the channel doesn't come on, the screen stays dark instead of drizzle, only the stand by light comes on | Replace diodo zener d412, 10v e d840 zener 5,6v | DJ PITUKA | |
| PHILIPS |
32PHG4900 32PGH5000
TPM10.1L |
Inverted image after board change. | Access service mode (menu+1999+return). 1st navigate to option 74 (flip panel), press the right arrow on the remote control to enable the flip panel option from off to on. 2nd navigate to option 19 (virgin mode), press the right arrow on the remote control, to enable the virgin mode option, from off to on. Turn off the device using the remote control. wait a few seconds and turn it on again. | Credit to maikon ramos from eletronicabr.com (I only corrected the Portuguese errors. lol). | Eletrônica R-Tec |
| CENTURY |
SUPER COLOR
|
Popping sound | Qa21=bc547 | Replace it with another and run to the hug | Antonio Carlos (Eletrônica Renascer) |
| PANASONIC |
TC-L32C5B
|
At 220v it turns off when changing channels or with an image and the LED flashes 1x | 1 defect the glue conducts from the dz7207 of 6.8v causing q7203 to conduct preventing the IC 7201 from oscillating and we do not have 390v in the c7212 after solving this second defect turns on the TV power supply pfc everything works and the backlight blinks 2 times and then turns off and led flashes 1x this defect was resolved by changing the two inverter transformers | Measurements of the defective inverter transformer at 1.4Ω/2.72 mh on both outputs 1333Ω/ 1000 mh measurements of the scrap transformer but which worked at 1.4Ω/2.24 mh and out 1342Ω/ 842 mh tested with esr02 pro | BRUSKE 2019 |
| TOSHIBA |
TV2158(N)SF
|
LED pulsating and rumbling in the speakers, sometimes it turns on but the characters keep oscillating to the right | D840 of 5.6v changing the power supply to 6.6v to 7v just changed and it was new | Edson_tec | |
| SAMSUNG |
PL43F4000AG
|
Turns on, but after 30 seconds the image disappears and only the audio remains | After changing the transistor q5014 on the board on the side, the TV worked normally! | Replace only for the original! | Bruno concertos ltda |
| TOSHIBA |
U18
U18 |
Strip of about 10cm on the right side of the tube and had no characters and sometimes tsound was no command on either the keys or the control | In my case, the zener diode d418 was short, I replaced it, it was normal......let's look for God while it can be found | lazaro lemos | |
| SONY |
MHC-RG190
|
Display off | R908 (1r) | Flavio FJLeletronica | |
| SEMP |
TV1483
|
Blue fabric | Diode | The diode on the tube board d901. | reprasom sao benedito ce |
| PHILIPS |
HTS3576
|
I'm sound | Som plate | Wellington Brandão de Farias |