Repair Tips
Search:
Results: 88103
Results: 88103
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| CCE |
HPS 1471
|
I plug it into the socket, the LED lights up, I press it, it turns on the normal gun power supply with 103v but it doesn't turn on anything, it just stays with the power supply stabilized | Resistor in position fro402 was open | Just replace and go for the hug | |
| TOSHIBA |
32L2400
|
Burns the bus frequently. | Excess current in the LEDs. | Remove 2.2Ω resistor r765. | Persio (TVCompany) |
| PHILCO |
PH14D
|
Does not turn on display off | Res 819 intermittent defect | Replace resistor even though it measures good | Flavio FJLeletronica |
| PHILIPS |
20PT3336/78
|
It turns on and off, tsound are times when it turns on, holds it for a second and turns off | Replace 6001 zener diode next to the varicap, 33v | DJ PITUKA | |
| CCE |
LK42D
|
Doesn't start | Replace capacitors 1000x35 c44 c37 | wesley | |
| AOC |
L32W931 LTA320AP05
|
Main board matar 5v switching power supply | Killing 5v from the switched power supply | Ramiro | |
| LG |
42LD420
|
Stand by LED blinking and TV won't turn on. | Ar1201 open | Check all resistor banks connected to the TV's memory, one of them will be open. | Alex Lopes <small> |
| SAMSUNG |
CL-21Z50MQ
KSCA |
Voltage coming out of the d813 keeps varying | Capacitor 804 on the power supply primary | Touch by another 10u by 50 volt electrolytic | lucinaldo |
| SAMSUNG |
PL42B450B1
|
Won't turn on, dead, no stand-by | Tv without voltage on the capacitors (cp81-802) on the power supply primary. | Polyester film capacitor 68n x 1000v. (cs808) replaced and resolved! | Multimídia |
| PHILCO |
PH21MSS
|
Burning vertical | Tall vertical power supplys | Transfomador driver | edval |
| PANASONIC |
TC-L42ET5B
|
Turns on BL twice, then goes into protection and the red LED flashes. 1 time | Usually bulbs, but after changing, the defect persisted | Changing protection resistors on one of the LED power channels, against overvoltage, on the inverter PCI, 2 x 684 and 1x 563, a leak would raise this voltage, tsoundfore triggering the protection. | davi.sls |
| PHILIPS |
32PFL3406D/78
|
Does not tune channels | Reg. 7123 de 5v | Imagem | |
| ONEAL |
OPB1115BT
|
I'm sound | Regulator 7812, 12v supply | Replacement | MaTões Ass. Teécnica |
| PHILCO |
PHT660N
|
No sound on all speakers | 220x16v raw capacitor e27 | Replace and practice for the hug | orlando lott |
| PANASONIC |
TC-24U400
|
Doesn't start | TV doesn't turn on, power supply without 5v | Zener diode with pass d7307--- 7.5volts | oskarala |
| SAMSUNG |
UN32EH5000G
|
No image, blacklite working | Capacitor CG02(next to ICG1) on t-con | robson | |
| SEMP |
LC3243
|
Does not turn on, no LED lights up | Change c842 and c843 c864 c865 all 22x50v | C842 2 843 if it gives 5v and the relay doesn't hit, replace c864 and 865 | Center som |
| PHILCO |
PH42F10DSGWA
|
The screen LED does not light up | Shorted capacitor smd cw21 and smd resistor rw48 near the | Celio Paulo de oliveira | |
| SAMSUNG |
LN32A450C1
|
It doesn't work, not even the STBY LED lights up! | Secondary power supply dead! r806 open on pfc line. This resistor is responsible for powering the tb801s and icb801s trafo | Replace for another 10r 2w. good luck! | EvandoViana |
| SEMP |
TV2134
SK11 |
It turned off in minutes. Then it stopped turning on. it generated high and turned off when presenting image. | Q606 (s8050). | In the circuit, the transistor had no defects and anomalies when cold. only after a few minutes, when it warmed up. then it crashed once and for all. (it was tiring, you see. lol) | Eletrônica R-Tec |