Repair Tips
Search:
Results: 88106
Results: 88106
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| PSU |
FSP205
|
24 and 12v low | Check capacitors, u2, pc1 and pc4 | Kübra | |
| PSU |
FSP205
|
Without 24v | Disable power cable to inverter | Check inverter, d6, d8, ic2, ic1 and t1 | Kübra |
| PSU |
FSP205
|
Without 5v | Check and replace ic201 t3 | Kübra | |
| PSU |
FSP205
|
Burn fuses | Check bd1 ic201 q1 d1 q8 e q9 | Kübra | |
| PANASONIC |
TC20A7
|
Vertical partially closed at top and bottom | Diode d413 was replaced with severe leakage | José delta line | |
| SIEMENS |
WD14H
|
Washing machine doesn't turn on | Main control board replace 100r power resistor which is broken and ic lnk304gn | zinom | |
| PHILIPS |
14PT314
|
LED flashing power supply varying | Flyback or 82k resistor changed from the primary | Lucas silva | |
| SEMP |
2051NAV
U18 |
TV turns on with a semi-dark screen and reduced frame, with retrace lines at the top and bottom with a cup effect. normal primary and secondary power supplys. | Defective photocoupler. | Replace mentioned component. | Eletrônica Medeiros |
| SAMSUNG |
UN40F6400
|
Doesn't start | The relay was knocking and it wouldn't turn on, I checked that the voltage on the rectifier bridge was very low, I took all the bridge measurements with a digital multimeter on a diode scale and everything was normal, I decided to change the rectifier bridge anyway and to my surprise the problem has been resolved. | cdias | |
| AOC |
LC42H053
|
TV doesn't turn on | Capacitor 16v 330µf; e o capacitor 25v 1000µf | Replacing the two 16v 330figenia capacitors and the 25v 1000μF capacitor | Moisés Costa |
| PHILIPS |
FWM397
|
No sound on low output | Check the voltages, if everything is ok, remove the smd resistor r726 connected to pin 13, if it doesn't solve it then you have to change the stk | Remove r726 tip from friend vipo | beto2828 |
| SONY |
KDL32BX325
|
Sometimes it turns off by itself or doesn't turn on, red LED flashes twice | Shorted or charred capacitor, c967. | Replace capacitor c967. | WAINER TELECOM |
| SEMP |
1451NAV
U18 |
Does not turn on only with stand by access | Cracked solder on board | I resoldered the whole board and it was as good as it left the factory | Biel eletrônica.com |
| SAMSUNG |
CL29Z58MQ
|
Tsound is sound with the image darkening becoming reddish | After a lot of searching I found a defective diode dv202, it is close to the memory IC | Just replace it and solve it | Luiz videotek |
| PHILIPS |
MCM1150
|
Does not turn on/display flashes a few segments | Cristal y1 (cristal 32,768khz) | To replace | duc40rj |
| SEMP |
DL4245W
|
Does not turn on/dead | Db901 diode with leakage and altered 1.5m resistor rb919 | Replace of the same | ELETRO SYSTEM |
| PHILCO |
PH21MSS
|
Power supply | Burning ci ncp1337p from power supply | Replace main capacitor in the power supply primary 220 × 400 | batista |
| CONSUL |
CMS180BH
|
Does not accept programming or does not turn on. | Check microswitches and membrane. | Armindo Caldeira | |
| SEMP |
TV1454(P)SL
V2.1 |
It doesn't turn on, it has all the voltages but the LED doesn't even light up | V233 transistor c1815 da power supply 3v3 | Replace v233 | beto2828 |
| SAMSUNG |
UN40EH5300G
|
Does not connect to Netflix or applications, error message | Late date and time | Adjust date and time in real time and update software via the internet | Maike Sorriso-MT |