Repair Tips
Search:
Results: 88118
Results: 88118
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| LG |
29FU6TL
|
Image with cup effect | R318 was replaced, 3k9 resistor open. | José delta line | |
| PHILIPS |
29PT9467
|
Cushion effect | Q440 (irf630) shorted and 6.8r region 440 open | Replace both | Laercio |
| SEMP |
2143 (C) SL
|
Does not turn on, relay hits and then turns off | Cold soldering | Resolder r308 and r309 on the vertical line | Mário |
| LG |
26LG30R
|
When turning on, audio gaps appear, you have to turn it off and on again. | 1.2 volt regulator heating up and creating resistance to the electrolytic capacitor on the back of the regulator, just change it and be happy. | Adriano oliveira | |
| SAMSUNG |
HT-F4504ZD
|
Doesn't start | Blown fuse and mosfet 10n65a | Replacing them (note I put the p9n65zf mosfet) | zeluiz |
| SEMP |
TV2916
|
Vertical closed turns on and then turns off | R311 smd of 3k3 open | Just replace it and that's it | orlando lott |
| SEMP |
2982
|
Turning off | R852 changed 220k | Replace resistor r852 | @edilson.oficial.al |
| CCE |
STILE D32
|
Turns on, turns off normally, lights come on and go off, the green LED on the power supply flashes and meets the normal control type | Switch power supply | Switch power supply | ASL ASSISTENCIA TÉCNICA TONINHO |
| CCE |
STILE D32
|
Power LED does not light up | Change power supply | Replace font | ASL ASSISTENCIA TÉCNICA TONINHO |
| CCE |
STILE D32
|
The stand by LED turns orange without command on the control, it doesn't turn on..it should turn red and when turned on it goes through the orange then green stage | Replace the main board | Replace the main board 1107314704 | ASL ASSISTENCIA TÉCNICA TONINHO |
| TOSHIBA |
TV2177
|
With very blue images and only turning off when the av returns to normal | Transistor q907 | FRANCISCO FERREIRA VILA BU MARANGUAPE | |
| PHILCO |
PH21SS
|
TV turns on then turns off | Capacitors c562,c563,c450 | Replace capacitors c562, c563 1000u25v and c450 2kv680p | marquinhos eletronica |
| AOC |
LE40H157
|
The logo appears and then disappears, leaving the screen dark | Had 4 swollen capacitors | Replace c711, c714, c717 e 746 | ELETRÔNICA MARTINS JN |
| STI SEMP TOSHIBA |
DL2970(B)
|
Sometimes it doesn't tune channels, sometimes it does | In my case it was u206 reg.3.3v near the tuning sector | Mega Center | |
| PHILCO |
TP2053
|
I'm sound | Tv phico trc tp2053 without sound, enter service mode, go to the page wsound it says model, evg, 12er, syscol... and set the model to 18. * service mode: 1st with the ac cable disconnected, press menu and connect the ac cable, without releasing the menu key 2nd ... without releasing the menu key, press the vol+ key and keep both pressed for 5 seconds. 3° release both keys and turn on the device. 4° wait until the image appears. then press the menu key. to navigate in service mode use the cursor keys on the cr or the vol and channel keys on the panel... change the model code to 18.. | DJ PITUKA | |
| PANASONIC |
21FX30L
|
Stop | After a lot of work because the horizontal output was leaking, the 140 volts appeared but it didn't generate because tsound weren't 5 volts. | <small> |
|
| H-BUSTER |
32D05HD
|
Does not turn on the lamps | R 6 smd 10Ω in open power supply. r 6 and not 26 as I had said before! | I put a common resistor and the lamps turned on! | Ismael Nobre |
| H-BUSTER |
32D05HD
|
Does not turn on the lamps | R 26 smd 10Ω in open power supply | I put a common resistor and the lamps turned on! | Ismael Nobre |
| SAMSUNG |
CL21C650ML
|
Turns on with the screen full of retrace lines without key commands | Dz209 | Replace the 9.1v dz209 | Sinailson furtado |
| PHILCO |
PH40U16DSG
|
TV turned on normally with the LEDs on without image | Capacitor on the v.com shorted, I just forgot to write down the number on the board, the fuse was open, it's on the opposite side of the fuse on the v.com, change the capacitor and the TV will be fine | Replace | <small> |