Repair Tips
Search:
Results: 88183
Results: 88183
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SAMSUNG |
CL 29K40MQ
|
The standby LED starts blinking, turns off but tsound is no image | I changed the r-413 and it worked | ||
| PHILCO |
PCS2952
|
This TV had a leaking flay back, I replaced it and when I turned it on the TV it had a red screen I thought it was the resistors on the kinescope board but it wasn't. | I had to do a procedure that is as follows: turn off the TV in general and hold down the two channel keys and turn on the TV, and hold for three seconds, and everything will return to normal. | ELETRONICA DIGI SOUND, NOVA TIMBOTEUA PA | |
| SEMP |
TV2934
SK-91 |
Short strw6556a, power supply diodes. | Electronic cap. 220/450v power supply | AAndrey | |
| PHILCO BRITANIA |
PH14D
|
Led flashes radido No start r839 82k rising c 843 c 845 also varies in memory | Grava eprom | PHILTEC | |
| PHILIPS |
29PT5645
|
Retraction line tda6107ajf/n1 | No image closing on the sides | PHILTEC | |
| LG |
CP20K42A
|
It turned on, sometimes it took a long time to turn on, and it didn't obey commands on the keyboard and control. | It was the diode near the epron that was leaking and it was killing the 5v that feeds the epron | Leaky diode (d23) | diego lima, nova timboteua pa |
| PHILCO |
TPF2121
|
The LED turns on, presses power, the LED goes off for a few seconds and starts flashing | Wide capacitor | edezio eletronica | |
| DVD SEMP |
SD-8071HD
DVD |
When stopped, the panel does not light up | D4 good | Replace | LUCIANO |
| TOSHIBA |
U16
|
Dark image | Polyester from a. voltage on the tube plate. | Djalma de Oliveira |
|
| CCE |
HPS-2185
|
The LED flashes, the tube cannon lights up, but the screen does not light up | Picture tube | Replace it of course! | Marcondes Lima, Jaicós-PI |
| PHILIPS |
HTS3510
|
Turns on normally reads the disc but tsound is no sound | U507 cq1565rt d504 fr107 | Replace them replace d504 without measuring as it has a small leak | antonio nobrega patos pb |
| TOSHIBA |
2922
JFS |
When turned on, the LED would light up and go out immediately, leaving the power supply with a lot of charge. | C-819 of 10x50v changed | Replace for another | ELETRONICA CAVALCANTE EM MARTINOPOLE-CE |
| HICOM |
RCR-4800
|
Changing channels does not tune channels | R78 aberto | Replace the same | Tec Center |
| SEMP |
1492LAV
U16 |
LED doesn't turn on | Power supply is missing vcc pin 17 of the micro | Replace r 432 2.7k | E.MATOS |
| PHILCO |
PH21M SS
|
ñ league not led | Diodo zener 18v q 802 r402 r846 10Ω d 811 | Replace e so file | fofinho |
| LG |
29FX5CL
|
Does not turn on, LED is off, zero secondary voltage, tries to start and turns off | Primary power supply is not oscillating | Photo coupler | cabessaonatal |
| PHILIPS |
25PT5646/78
L04U AA |
Does not turn on, LED flashes 10 times | Capacitor c2415 | Replace with new | Elson ek eletronica |
| MAGNAVOX |
29MT4515/78
L01.1L AC |
Does not auto tune channels | Corrupted eeprom data | Rewrite eeprom with original data | Elson ek eletronica |
| LG |
29CC9RL
|
Dead, | Fly back bcs25-n545 = 6174v5017a | If you couldn't find this fly, you can replace it with 6174v 5003 r without any replaces, 100% compatible | DEBIQUE |
| SAMSUNG |
CL-21Z50
|
Turns on, normal sound + no image | C 508 on tube plate | And just remove it from the board and it will work again | ELETRONICA AUTO TREVO |