Cineral Repair Tips
Search: cineral
Results: 427
Results: 427
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
CINERAL |
TC 1411
|
Dead | I701 (micro) | Replace the micro | Tecvideo |
CINERAL |
PL-2110
|
Turns off after a few seconds or minutes | Q103 | NUNO RJ | |
CINERAL |
TS 2977
|
Turns off some time after turning on or turns on whenever you want. | Causa: c116 (330uf/50v) | ||
CINERAL |
PL2110
|
Excess horizontal width | C227 (10uf) replace with 22uf/105º/(63v or more) it is important to be 105º as the 85º ones in this position get too hot. | ||
CINERAL |
2910P
|
Everything works fine at 220v at 110v there is no sound | Check c530 c532 | ||
CINERAL |
PL2910
|
Image interference | Silly, disgusting | ||
CINERAL |
TC-1411
|
Str50103 faulty in 220v networks | 1- change c608 from 0.047uf x 200v to 0.015uf x 250v 2- replace 22Ω r804 with 51Ω or 47Ω / 3w 3- replace 10Ω r805 with 51Ω or 47Ω / 3w 4- on the side where r805 joins c812, solder the anode of a ske4f 1/04 diode, connecting the cathode to the positive of a 220 uf x 250v electrolytic capacitor, connecting its negative to a nearby ground. 5- in parallel with the electrolytic capacitor, install a 2.2 kΩ resistor 6- add a bigger heatsink to the str | ||
CINERAL |
C1420
|
Does not oscillate | Q806 | ||
CINERAL |
PL-2910P
|
Image interference | C525 e c532 | ||
CINERAL |
TC-1411
|
Vertical closed | Qa02 | ||
CINERAL |
TC-1411
|
Dull | Stop07. | ||
CINERAL |
2110PL
|
Doesn't work | Q103 open, which takes the 3v3 to the micro. | ||
CINERAL |
TC 14/2022
|
No characters | R704 | ||
CINERAL |
TC-2053N
|
Dead | D825, check dz808-dz809-dz810 for new | ||
CINERAL |
TC2011
|
Inoperative. | Defective microprocessor. | ||
CINERAL |
TC - 14/2022
|
No characters | R704 = 1k | ||
CINERAL |
TC - 14/2022
|
No audio | R706 | ||
CINERAL |
TC - 14/2022
|
Dark screen, when you turn on the TV it brightens | R760 | ||
CINERAL |
TC - 14/2022
|
No color | Rahkha = 1 k | ||
CINERAL |
TC - 14/2022
|
Osc, when connecting master key | R410 = 10k |