Search: lg
Results: 4929
Make Model Symptom Problem Solution By
LG 21FS4RLG
Image flickers, with retrace lines and even color flaws... the problem is intermittent and only occurs when the equipment is cold and turned off for hours and after some time of use the image stabilizes and the retrace lines disappear Check leakage and esr of capacitors *c814, c835 and c850 which are technically close Thiago
LG 14FK3RB
MC059D
Vertical closed 2cm top and 4cm bottom R 313 from 47k altered to 69k Replace This email address is being protected from spambots. You need JavaScript enabled to view it.
LG 32LE5300
No sound, it appears that the phone is on Resoldering the headphone connector. just run for a hug Elizeu. DF
LG 47LEX8
Hitting the relay, sometimes it would turn on, the logo would appear and it would restart Capacitors on the 24v line changed, after the change, the defect continued, I replaced all the power supply capacitors, and did a complete resoldering of the board and the TV started working again levy souza
LG 32LJ601C
Tsound is no 12 volts for the display Ci of the back light circuit that generates the 12 volts, change it ze maria tvs
LG RP1CB25A
MC059A
Horizontal synchronism Diode d 501, aberto After changing the TV ok. George Pontes
LG 52LG70YD
TV with back light on, no sound, no characters or image Do reballing, remove the heatsink from the ic100 and heat the processor at 450 degrees with a thermal blower on the top of the IC, for around a minute, doing it in a circle.
LG 37LD460
Does not turn on, nor does the standby LED light up Ceramic capacitor c458 shorted Replace capacitor c458
LG 42LK450 32LK450
It doesn't tune the channels and when it tunes it works for a while and then disappears Lack of 12 volt voltage on the varicap selector.. touch ic3701 Rv Eletronica (Ricardo)
LG 50PQ30TD
Hdmi inputs inoperative/image flickering or no signal Leaks in several metallic smd capacitors around the ddr2 memory ic-300 and ic-301 Replace c-810 and c-826 (22x16v) / c-834 and c-2102 (47x16v) c-323 (100x16v) and that's it, it's great, only one case had to go into the service menu and rename the hdmi inputs. ROBUSTO63
LG CL87
When turned on, it comes with audio, but with a high-pitched horn sound. The cause of the defect is the clock oscillation x600 crystal. located next to two capacitors on the left facing away from the device. Replace of the same. With the device turned on, place your finger on the indicated crystal and it will make a different noise. JC Eletrônica Cícero
LG 50PQ30TD
Hdmi inputs inoperative/image flickering or no signal Leaks in several metallic smd capacitors around the ddr2 memory ic-300 and ic-301 Replace c-810 and c-826 (22x16v) / c-834 and c-2102 (47x16v) c-323 (100x16v) and that's it, it's great, only one case had to go into the service menu and rename the hdmi inputs. ROBUSTO63
LG 50UN7310
Turns on normally, but turns off, turns on but no image, normal sound. Main screen of the display heating up. put heatsink with thermal paste. measures; This main ci, the one that seems to be working, however, does not give commands to the vcc of the vgl, vgh of the panel. LEANDRO
LG 43LJ5500
Does not connect wifi Wifi card supply voltage less than 3.3 volts Leaky transistor, on the main board next to the connector that comes from the q2300 (za) power supply, lowering the voltage to 2.8.
LG 32LE5300
No sound. TV informs you that the phone is connected. Ceramic capacitor shorted on the main board c1119 - close to the phone connector on the side of the board. Just remove the capacitor. Filipe Furtado
LG 49LJ5500
Wifi off / can't find wifi Update software over lan network Success to all marigwr
LG 60PA6550
Turning off after a while Complete resoldering of PCBs y, z and power supply was carried out. The problem was resolved and another one appeared. 1 fixed horizontal line on the screen. Flat bμFfet cleaner next to the line. not resolved. cleaning of the 3 flats close to the line was carried out and it was resolved. good luck !
LG 21FU1LR
CW81A
Replace R 844 of 4.7k Replace Mauro Mascarenha Tel. (88) 981422821
LG 60UM
Sometimes it cuts the image and only audio remains! but always with the LEDs on! on the t-com board, if the FET300 IC heats up, it releases 17v and the image comes back, sometimes shaking the right side, change the t-com Sometimes with an image, sometimes not! but always with the LEDs on! changing the t-com Rodrigo cofferi
LG 47LA6200
Blacklight comes on but no characters - no image - 12 volts were not enough on the tcon Capacitor on main board - c2435 shorted killing the 12 volt line. George Luís