Panasonic Repair Tips
Search: panasonic
Results: 2911
Results: 2911
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| PANASONIC |
EURO 2M TX25MD3
|
St/by only/ whistle on sound when fixed | Q1212 bc847b blasted - when replaced set ok apart from whistle on sound caused by audio proc chip | ||
| PANASONIC |
EURO 2M
|
No sound (relay clicked a few times before set switched on). | Resolder xtal. x2101 beside audio processor chip ic 2101. | ||
| PANASONIC |
EURO 2L TX28LD1
|
Field collapse | Tda8175-3 fop chip & d456 ma2160 - chips in short supply replace it with a tda8177. mod kit part no tzs9ek026-1 from seme | ||
| PANASONIC |
EURO 2L TX25MD1
|
No picture - sound ok | F851 o/c then field collapse noticed. fit fop kit tzs9ek026-1 & blew fop chip - d425 s/c & r702 o/c | ||
| PANASONIC |
EURO 2L TX25MD1
|
Filed foldover with thin r & g lines at top | Ic451 tda8175 & d456 ma2160b - kit pt no tzs5ek001 | ||
| PANASONIC |
EURO 2L TX21MD1
|
White snow effect on screen on high brightness | Ic601 vdp3108a digi sigs proc chip | ||
| PANASONIC |
EURO 2L TX28LD1/B
|
White screen with vert black thin lines from cold - ok if ic601 heated | Ic601 vdp3108-25 luma/chroma proc chip | ||
| PANASONIC |
EURO 2L
|
Vcr incompatibility - pulling at top | Incorrect chan in use - use chan 0 (av) | ||
| PANASONIC |
EURO 2L
|
Tuning drift & loss of sigs mid range | Resolder earths in tuner | ||
| PANASONIC |
EURO 2L
|
Top foldover | If tda8175 not available fit replacement chip (no n/k) & 1. r452 remove and fit wire link, 2. r457 change to 2.7k, 3. r456 check that it is 10k, 4. r460 check it is 18k, 5. r464 check it is 0r27 | ||
| PANASONIC |
EURO 2L
|
St/by only | Ic601 vdp3108-25 sigs proc chip faulty | ||
| PANASONIC |
EURO 2L
|
No e-w corr | R702 22r 1/2w o/c;c554 510n 200v o/c | ||
| PANASONIC |
EURO 2L
|
Int herringbone pattern on rf & scart | Legs on ic 601 ( under the metal shielding ) dry joints | ||
| PANASONIC |
EURO 2L
|
Fop chip blows regularly | Replace assoc diode as well | ||
| PANASONIC |
EURO 2L
|
Field collapse | Noisy wfm from ic601 vdp3108-25 sigs proc chip - chip faulty (£35) | ||
| PANASONIC |
EURO 2L
|
Field collapse | Fit kit tzs9ek002-2 (ic601 & eeprom) - (£27 from seme) | ||
| PANASONIC |
EURO 2L
|
Cuts out on high brightness - beam curr lim u/s | R558 120k possible, micro ic1201 should sense beam i pin 27 - not happening due to faulty micro - new µ needs reprog in a reader | ||
| PANASONIC |
EURO 2 TX29AD1DP
|
Dead with psu tripping | C622 47µ 50v, c634 1µ 50v | ||
| PANASONIC |
EURO 2 TX29AD1DP
|
Bright red raster which went to field collapse then tripped off | Dis pins 5 & 6 of eeprom i941 & re-try. if pic returns, albeit short, then eeprom faulty. reqs reprog or a pre prog one fitting (x24c0706ah - pan- cheapest, or seme). also replace relay tse10818 - cause of initial trouble & remove r668 | ||
| PANASONIC |
EURO 2 TX29AD1
|
No sound/pic just ticking from relay | Could be lop fault but relay faulty in this case |