Panasonic Repair Tips
Search: panasonic
Results: 2911
Results: 2911
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| PANASONIC |
EURO 2
|
St/by mode difficult to enter/leave | Sticking relay contacts rl610, clean or replace pt no tse10818 | ||
| PANASONIC |
EURO 2
|
Snowy signals | C111 0.068µ leaky | ||
| PANASONIC |
EURO 2
|
Snowy pic with smeary red & white - txt ok | Same via scart - dig proc chip vdp3108-29 faulty. pan supply improved type along with sm caps, eeprom & instructs | ||
| PANASONIC |
EURO 2
|
Servicing the panasonic euro-2 chassis | See tv mag jun 1999 | ||
| PANASONIC |
EURO 2
|
Self check mode | To enter this press the "status" key on the remote at the same time as pressing the "programme down" button on the tv. beware as this procedure will erase all previously stored channels & the set will need retuning. | ||
| PANASONIC |
EURO 2
|
Relay pulsing once per sec | When over-ridden ht very low - c637 2n2 polyester cap pin 2 i611 | ||
| PANASONIC |
EURO 2
|
Ragged verts & pic breakup | Ic601 dig at proc chip vdp3108appa1 | ||
| PANASONIC |
EURO 2
|
Osd has white flecks, no red on txt, no/weak sync | Ic601 vdp3108appa1 vid proc chip | ||
| PANASONIC |
EURO 2
|
No line drive, psu running, led flashes once per min | Replaced jumgle i/c eeprom kit tzsek002. after fitting go into self test to unlock tuning memory | ||
| PANASONIC |
EURO 2
|
Main psu remains on in st/by causing bright lights & phospor burn to crt | Relay rl6101 on front panel sticking - replace (pt no tse10818) & r668 on panel e (& also crt!) | ||
| PANASONIC |
EURO 2
|
Int field jump/jitter at bottom of screen | D507/d508 and r507 | ||
| PANASONIC |
EURO 2
|
Goes off aft 2 secs at sw on - ht present | Replace tzs9ek002-2 kit -m incs jungle chip & eeprom | ||
| PANASONIC |
EURO 2
|
Goes into lines then cuts out when hot | Check xtal x601 & ic601 vdp3108-30 | ||
| PANASONIC |
EURO 2
|
Flyback lines at top - int | D456 ma2160b | ||
| PANASONIC |
EURO 2
|
Field top foldover | D456 16v zener ma2160 in fop stage | ||
| PANASONIC |
EURO 2
|
Field scan problem & shuts down | Dis pins 5 & 6 of earom ic1203 - if field opens up then earom is faulty otherwise check vdp ic601 & field o/p | ||
| PANASONIC |
EURO 2
|
Field scan int varies & shuts down | Ic1203 eeprom st42c08cb1 | ||
| PANASONIC |
EURO 2
|
Field collapse & tripping | R7000 180k & r7005 150k bias for str10006m - on side pcb | ||
| PANASONIC |
EURO 2
|
Field collapse | Change fop chip, d456 16v zener & d454 & check elects in fop stage | ||
| PANASONIC |
EURO 2
|
Field - only an inch of pic showing at top | Ic1203 |