Panasonic Repair Tips

Search: panasonic
Results: 2900

Make	Model	Symptom	Problem	Solution	By
PANASONIC	TC20A12	Works for 1min and then turns on and off	D102 shorted, heats up reg 7805 ic1202 and goes into protection		Jcgiantomaso
PANASONIC	TC14A10	Does not tune channels	Resistor da power supply bt (r106-470k)	Replacement	Domingos da Eletronica
PANASONIC	SA-AK300 CD STEREO	Only appears on the display (f61)	Cold solder on the transistors and on the sound output IC		Marcone
PANASONIC	TC29KL05	Two side bars closing the horizontal	Please 753 large batch pincushion-in	Replace q753	firmino
PANASONIC	TC-14C06	Unfocused and blurred image	The socket connected to the tube	Replace the socket connected to the rgb board connected to the tube	jarbas santos
PANASONIC	TC-16C06	(blurry unfocused image)	The socket connected to the tube	Replace the socket connected to the rgb board connected to the tube	jarbas santos
PANASONIC	TC 14A10	Doesn't work	Ci 301=la7840 (only works with the original ci)	Replace only with the original ci. ok?	MARCONE
PANASONIC	TC14C7	Queima s.h. d2499	Possible loose solder on the terminals of d566 which is connected to s.h. collector		Bruske
PANASONIC	TC-20KL04	Turning off	Protection circuit	Remove the q520 and q580	CAMP
PANASONIC	TC29KM03	TV works with closed horizontal, horizontal line on the screen, with sound, tunes channel.	Capacitor polyester 0,39uf/250v c568	Replace capacitor	taquari eletronica - afonso ( teresina piauí)
PANASONIC	TC-29G9L	Turns off immediately after turning on, having to unplug it to reconnect it	R564 137k and r556 22k open		nene
PANASONIC	TC21S1RF Z5	No image. don't tune in	C859 shorted		This email address is being protected from spambots. You need JavaScript enabled to view it.
PANASONIC	TC 20C6	Setting up protection	D835 diode shorted		pardalzito
PANASONIC	TC-14A12 *	Turning off after 1 minute, and when it turned off, I noticed that the LED was blinking slowly, then it turned off with the key, it worked normally and turned off.	C-519 its value is 22/160v I replaced it with 47/250v and it was normal again.	Its replace for another higher value.	wagner
PANASONIC	29KL05	When turning on it makes a horizontal noise and turns off	I will be outraged	Replace the capacitor c 563 390k open	itan
PANASONIC	TC29A10/29G9L	Doesn't start	Triggers the relay from the power supply and then disarms it.	Turning off the fly back the power supply voltage goes to more than 170 v. replace the fly back, the power supply only works with it in order. with the fly back in the circuit, the power supply goes to 88 v and immediately switches off.	Secam
PANASONIC	TC29KL05	Horizontal closed with a line in the middle.	C563 de 394j	Replace and run for the hug	serginhosond@yahoo
PANASONIC	TC20A12	When plugged into the power supply socket the voltage fluctuates and appears to go into protection	Power supply oscillating, change optocoupler, it goes into protection if grounding pin 36 of the micro TV remains connected in this case it was dz 511=10.8v with leakage.		Bruske
PANASONIC	TC14A9	Triggers protection	Vertical exit.	Replacement	This email address is being protected from spambots. You need JavaScript enabled to view it.(floripasc)
PANASONIC	TC29V50B	No audio	Ic 2302	Replacement	This email address is being protected from spambots. You need JavaScript enabled to view it.(floripasc)