☰

Panasonic Repair Tips




AIWA
BEKO
CCE
CINERAL
DAEWOO
FUNAI
GRADIENTE
GRUNDIG
HITACHI
ITT
JVC
LG
MITSUBISHI
PANASONIC
PHILCO
PHILIPS
PIONEER
RCA
SAMSUNG
SANYO
SHARP
SONY
THOMSON
TOSHIBA
VESTEL


Search: panasonic
Results: 2900
Make Model Symptom Problem Solution By
PANASONIC TC14A10
Vretical 5cm aberto. R425 open Replacement This email address is being protected from spambots. You need JavaScript enabled to view it.(floripaSC)
PANASONIC TC-14A9
MX5 		Does not turn on generates and cuts normal power supply Shorted vertical output Replace eletroclaudio aguas belas
PANASONIC 29KL05
Closed horizontal Capacitor acopramento c563 Replace c563 JOAO DANATS
PANASONIC TC-20C4
Crackling sound Dry c223 Replace component CSOM
PANASONIC SC-AK300
It doesn't turn on, the stbay light stays on 8817 friend of inacio 05/18/10 Relay q connect open transformer 6v relay replacement marcos melo cascavel ceara
PANASONIC NNST568WRUK
The plate and propeller motor that cools is directly connected Defective relay does not deactivate, stays on directly Help yourself leave your tip ELETRONICA ARNI-LEOBERTO LEAL /SC
PANASONIC TC-20A10
The screen appears blurred and in the shape of a rainbow Tube socket Replace for new eletroclaudio aguas belas
PANASONIC TC-20A10
On becomes off power supply inoperative Diodo zener d851 de 24v Replace for another eletroclaudio aguas belas
PANASONIC TC29KM03
Line from top to bottom horizontal C 568 of 394j x250vdcc with capacitance loss Replace for one of the same good luck EVALDO GOMES URUÇUI-PI
PANASONIC TC 29LK04
Burning horizontal outlet Q551/c5902 s.h. - r520 e 521/0,27Ω 1w - d556/rh 3g - c563/0,39p 250v - q753/d2693a - r768/10Ω 2w Replace them all eletroclaudio aguas belas
PANASONIC TV-20A7
Electrical discharge: short, change q801, q802, q805, d817fd312s, turns on and still did not oscillate. Replace ic 601 an-5192ka Replaced it worked normally. Eronaldo
PANASONIC TC 29LK05
GP3 		Horizontal closed, it was capacitor c563 when I put it in it didn't work but the resistor r768 de10r smoked I short the transistor q753 and the diode d556 and burn 2 resistors r20 and r21 of 2r7 Swapping them worked great. eletroclaudio aguas belas
PANASONIC TC14A8
It has a power supply, but it doesn't oscillate and the 9 volt output from the power supply is low. I removed the vertical output and it worked After changing the vertical outlet it worked normally José gusmao
PANASONIC TC20A12
Turns off, and the LED keeps flashing Ground pin 36 of the microprocessor edson proesi
PANASONIC TC20A10
MX5Y 		Tsound is no audio Replace c203 10uf/16v Replace c203 10μF/16v ELETRONICA CENTRAL ITAPOLIS SP
PANASONIC TC-29A8
NA6L 		TV when turned on goes into protection and only works if unplugged Defective flyback. Helio Eletrosonic
PANASONIC TC-29KL05
It doesn't turn on, I deactivated the protection on ic 451 pin 05, the screen was a little off, I turned on the TV and it oscillated normally. So I turned on the IC 401 protection and adjusted the screen. it worked normally. Doesn't start I deactivated the protection and adjusted the screen, then activated the ic 451 protection. VALDO RECIFE
PANASONIC TC14A8 TC20A8 TC14A9 TC20A9
MX5 		Three to four retrace lines at the top of the screen This symptom occurs when the memory (ic1102 - code s- 24c02adp) is changed or when the memory data is changed. Enter service mode chq3 and lower the vertical center vc to enter service mode check page 06 of the tc-14/20a9 service manual. Ronaldo
PANASONIC TC14A12
Only turning off after a few minutes I replaced c519 from 33mc 160v to 45mc 220 and tsound was no more problem Romeu
PANASONIC TC-20A7
MX3-R 		Power supply drops to 50 or 60v, closing horizontal or image shaking D811 is r818 Sometimes cold welding on the power supply causes this defect as well. Bruno.