Panasonic Repair Tips
Search: panasonic
Results: 2911
Results: 2911
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| PANASONIC |
TC-29KL03
|
Closes the vertical at the bottom | Capacitor smd na saida vertical | ||
| PANASONIC |
TC-21FX30L
|
Turns off in a few seconds with a dot on the screen | As a testimonial | ||
| PANASONIC |
TC-14RM15L
|
Turn on and off | D403 short or open | ||
| PANASONIC |
TC-29Z99L
|
Turns off intermittently | R518 change value to 3.3 r | ||
| PANASONIC |
TC-29Z99L
|
Turns off by itself | D511 with leak | ||
| PANASONIC |
TC-20G11 TC-29G11 TC-29A11
BR2 |
Function keys blocked, only power works. remote control works normally. | The keys were probably blocked by a TV function. | Enter service mode: with the television on, press the action and power keys simultaneously for 3 seconds. To exit service mode, press action until exit. | Renato Pareta |
| PANASONIC |
TX21MD3
EURO2M |
I'm ok htoff | +b3 off- f851 open | Burnt trans hdriver | pernalonga |
| PANASONIC |
TC14A04
|
Acting protection | Q-840 smd | To remove | luciano |
| PANASONIC |
TC-14A12
|
Image shifted to the right horizontally with a white "cloud" above | Cause: d558=ma185 shorted. obs. you can put 1n 5061 and it works fine. | Other substitutes: ba157, ba173, bay21, bay46, baw52. good luck everyone. | |
| PANASONIC |
TC20A10
|
Does not oscillate | Short vertical | Replace | ELETROCLAUDIOPE AGUAS BELAS |
| PANASONIC |
TC 20A10
* |
With vertical lines turning off in less than 5 seconds. It was changed and after being resolved, it turned on normally with no image and a blue screen appears. | C-452 and c-829 and r-106 amended | Your replace. | eletronica wagner |
| PANASONIC |
TC-29KL05
|
Hits the relay and turns it off (protection) | R556 open | Replaced | Reginaldo WK Eletrônica |
| PANASONIC |
TC-14A10
|
It doesn't turn on even when it's new | D 402 zener 36v | paulinho | |
| PANASONIC |
TV 14 OU 20 RM10L
|
Bad image, no contrast | See r 557 and or revise the line | Master Eletronica | |
| PANASONIC |
TC20RM10L
|
Blinking LED, power supply with a burning smell, and returning current. | D-810 (ar-s1-50) in short. | Replace with the same one, or with a2-85. | eletronica vinisom e tv |
| PANASONIC |
PAL20RM
|
Blinking LED, power supply with a burning smell, and returning current. | D-810 (ar-s1-50) in short. | Replace with the same one, or with a2-85. | eletronica vinisom e tv |
| PANASONIC |
TC20A12
|
Works and stops | I turned off protection (q 605) | Bruno | |
| PANASONIC |
TC-20RM10L
|
No audio | Micro burnt | This TV arrived without audio, the customer informed that this happened after a heavy rain, I tested the input to the audio ci with the ociloscope and found no signal, I decided to inject audio at the same point and I had audio in the speakers, ultimately micro burnt, as the signal comes directly from this, I looked for this one which is a tda9540h/n3/2/1916 smd and I couldn't find it, I had the information that the tda9540h/n3/2/1784 is the same, I looked for it and it was easier to find, but expensive in around R$50.00, I couldn't risk it with this price, I looked more and found it for R$13.00 in Rio Grandedo Sul, I ordered a part and replaced it and the TV worked normally | ivan@ |
| PANASONIC |
TC-20RM10L
|
No audio | Micro burnt | ivan@ | |
| PANASONIC |
20G11
|
Turns on normally, then turns off after a few seconds. | R556 ou c823 | Replace | c.edgley |