Panasonic Repair Tips
Search: panasonic
Results: 2911
Results: 2911
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
PANASONIC |
TC 20C6
|
Setting up protection | D835 diode shorted | pardalzito | |
PANASONIC |
TC-14A12
* |
Turning off after 1 minute, and when it turned off, I noticed that the LED was blinking slowly, then it turned off with the key, it worked normally and turned off. | C-519 its value is 22/160v I replaced it with 47/250v and it was normal again. | Its replace for another higher value. | wagner |
PANASONIC |
29KL05
|
When turning on it makes a horizontal noise and turns off | I will be outraged | Replace the capacitor c 563 390k open | itan |
PANASONIC |
TC29A10/29G9L
|
Doesn't start | Triggers the relay from the power supply and then disarms it. | Turning off the fly back the power supply voltage goes to more than 170 v. replace the fly back, the power supply only works with it in order. with the fly back in the circuit, the power supply goes to 88 v and immediately switches off. | Secam |
PANASONIC |
TC29KL05
|
Horizontal closed with a line in the middle. | C563 de 394j | Replace and run for the hug | serginhosond@yahoo |
PANASONIC |
TC20A12
|
When plugged into the power supply socket the voltage fluctuates and appears to go into protection | Power supply oscillating, change optocoupler, it goes into protection if grounding pin 36 of the micro TV remains connected in this case it was dz 511=10.8v with leakage. | Bruske | |
PANASONIC |
TC14A9
|
Triggers protection | Vertical exit. | Replacement | |
PANASONIC |
TC29V50B
|
No audio | Ic 2302 | Replacement | |
PANASONIC |
TC14A10
|
Vretical 5cm aberto. | R425 open | Replacement | |
PANASONIC |
TC-14A9
MX5 |
Does not turn on generates and cuts normal power supply | Shorted vertical output | Replace | eletroclaudio aguas belas |
PANASONIC |
29KL05
|
Closed horizontal | Capacitor acopramento c563 | Replace c563 | JOAO DANATS |
PANASONIC |
TC-20C4
|
Crackling sound | Dry c223 | Replace component | CSOM |
PANASONIC |
SC-AK300
|
It doesn't turn on, the stbay light stays on 8817 friend of inacio 05/18/10 | Relay q connect open transformer | 6v relay replacement | marcos melo cascavel ceara |
PANASONIC |
NNST568WRUK
|
The plate and propeller motor that cools is directly connected | Defective relay does not deactivate, stays on directly | Help yourself leave your tip | ELETRONICA ARNI-LEOBERTO LEAL /SC |
PANASONIC |
TC-20A10
|
The screen appears blurred and in the shape of a rainbow | Tube socket | Replace for new | eletroclaudio aguas belas |
PANASONIC |
TC-20A10
|
On becomes off power supply inoperative | Diodo zener d851 de 24v | Replace for another | eletroclaudio aguas belas |
PANASONIC |
TC29KM03
|
Line from top to bottom horizontal | C 568 of 394j x250vdcc with capacitance loss | Replace for one of the same good luck | EVALDO GOMES URUÇUI-PI |
PANASONIC |
TC 29LK04
|
Burning horizontal outlet | Q551/c5902 s.h. - r520 e 521/0,27Ω 1w - d556/rh 3g - c563/0,39p 250v - q753/d2693a - r768/10Ω 2w | Replace them all | eletroclaudio aguas belas |
PANASONIC |
TV-20A7
|
Electrical discharge: short, change q801, q802, q805, d817fd312s, turns on and still did not oscillate. | Replace ic 601 an-5192ka | Replaced it worked normally. | Eronaldo |
PANASONIC |
TC 29LK05
GP3 |
Horizontal closed, it was capacitor c563 when I put it in it didn't work but the resistor r768 de10r smoked | I short the transistor q753 and the diode d556 and burn 2 resistors r20 and r21 of 2r7 | Swapping them worked great. | eletroclaudio aguas belas |