☰

Panasonic Repair Tips




AIWA
BEKO
CCE
CINERAL
DAEWOO
FUNAI
GRADIENTE
GRUNDIG
HITACHI
ITT
JVC
LG
MITSUBISHI
PANASONIC
PHILCO
PHILIPS
PIONEER
RCA
SAMSUNG
SANYO
SHARP
SONY
THOMSON
TOSHIBA
VESTEL


Search: panasonic
Results: 2911
Make Model Symptom Problem Solution By
PANASONIC TC20C2
Fuse blowing f 801 and r 801 R 871 (10k) and r 870(39k) open or changed Replacing resistors r 801 f 801 r871 and r870 george pontes
PANASONIC TC21FX30L
Turns on standby and turns off Change q850 rhaus
TV PANASONIC TC20C21
Going out of tune. Change AFT LC151 coil ready jps elt cam . grande
PANASONIC TC21FX30L
Inoperative power supply turns on the red and green LED but does not arm Q850 was replaced with a short, change it and go for the hug Fico filÈ odair
PANASONIC 29KL05
Closed horizontal Indignation (390nf) MACC
PANASONIC TC-20A12
Doesn't work Ic 1202 regulator 5v heating zener diode d 1202 shorted or ci 1201 Zener diode d 1202 shorted or ci 1201 Alvaro
PANASONIC 29A12
Horizontal exit burn Changed the fly bank jaironuness
PANASONIC TC 14C4
TV doesn't turn on, just stays on standby (with LED on) Q 451 with leak Replace q451 which is close to the vertical which is leaking or shorted, after the replace the TV worked normally George Pontes
PANASONIC TC-29G11
TV activates relay but does not turn on, LED remains on. Open zener diode 602. replace with a general use or make a jump. MANTENOPOLIS
PANASONIC TC-21FJ32L
PC860 photo sensor next to the power supply driver in the test was good, replaced it and solved the problem fabiusmax
PANASONIC KL05
Doesn't start L c394 Replace of the same misso
PANASONIC GT-1422
Doesn't start B+ shorted to ground def. power supply c823 471/1kv shorted ELETRONICA ARNI - L. LEAL
PANASONIC TC14C06
Just catching channel 02 with drizzle R1186 (180r) aberto Luciano Fontes
PANASONIC 20G9
BRD1 		Blowing the power supply fuse 10k open resistor r-833 Replace the resistor edsontadeu
PANASONIC TC20A7
Dead C652 de 680pf x 2kv alterado Jaison
PANASONIC 14A10
MX5 		I didn't tune in to cable channels Varicap replacement sergio luiz
PANASONIC 14RM10L
Blocked channel, Press volume- on the panel and sleep on the control beto2828
PANASONIC TC 1404 A
TV works normally +or- 30 minutes later protection works by unplugging it from the socket and starts working again for a little longer and the protection activates again C559 7n5 x1600v Rolf Thomas This email address is being protected from spambots. You need JavaScript enabled to view it.
PANASONIC TC-20A12
When turned on, the TV oscillated and gave normal sound, but there was no high voltage. I checked everything was normal. I went to the bus and found that it did not collect the voltage from the faly back but did not emit it. It was raw solder on the bu emitter, I resoldered it and it was fine This email address is being protected from spambots. You need JavaScript enabled to view it.
PANASONIC 14C6
TV makes a buzzing sound at the power supply and doesn't oscillate without +b on the horizontal output Replaced d 835 short jaironuness