Panasonic Repair Tips
Search: panasonic
Results: 2911
Results: 2911
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| PANASONIC |
TX25AD2DP
|
Wont go into standby | Replace q667 bc547b | ||
| PANASONIC |
TX25AD2DP
|
Field collapse | Caused by faulty proc chip | ||
| PANASONIC |
TX25AD2DP
|
Dead with red led pulsing | Rl6101 could be burnt up | ||
| PANASONIC |
TX25AD2DP
|
Dead no standby light | Try replacing ic1801 | ||
| PANASONIC |
TX25AD1DP
|
If eeprom is replaced and set switches to "0" and normal settings will not memorise | Press status on remote and function down on tv | ||
| PANASONIC |
TX25AD1DP
|
Dark picture with sparking | Check brightness control on crt base | ||
| PANASONIC |
TX25AD1/DP
|
No pic - only 3 hor lines across screen 10cm separation | 1st dis pins 4&5 of earom(24co706a) & check if field comes back.it did along with e-w errors which proves fop chip ok so replace vdp3108 kit part no tzs9ek002-2 | ||
| PANASONIC |
TX25A2X
|
No text | Check c3517 100nfd50v | ||
| PANASONIC |
TX24T1
|
Blank unfocussed raster? - sound ok | L353 on crt base | ||
| PANASONIC |
TX24A1
|
No sound/vis - chan no. displayed | Ic801 str54041 - & check dry joints | ||
| PANASONIC |
TX2482
|
No sound - osd & scart i/p ok | Tda4505m (used tda4505e + mod). | ||
| PANASONIC |
TX2482
|
Dead - loptr s/c | Replaced loptr, r567 1a cct prot o/c, 1r2 2w resistor from s3 on sec of smps trfmr (27v driver supply) | ||
| PANASONIC |
TX21V2
|
Trips at sw on - eht comes up briefly | Str54041-m in psu faulty | ||
| PANASONIC |
TX21V2
|
Low ht 60v | Check balls | ||
| PANASONIC |
TX21V1RE
|
Initial eht rustle then chan no only | Psu ok on bulb, l303 10mh 12v feed coil to citac etc o/c | ||
| PANASONIC |
TX21S3T
|
Whistle only | Dist line drive wfrm - pin 9 ic601 only 3.7v (8v); d861 1ss133t-77 hi res | ||
| PANASONIC |
TX21S3T
|
Service mode entering | Select chanel 60 set sharpness to minimum press timer on remote at the same time as the down arrow on the front of the set - press store after each adj to store | ||
| PANASONIC |
TX21S3T
|
No sound - ok thro scart i/p | No o/p from ic601 - chip faulty | ||
| PANASONIC |
TX21S3T
|
Negative picture with agc overload on tuner pictures ok from scart | Replace eeprom (store previous data values and then enter into new chip | ||
| PANASONIC |
TX21S3T
|
Lack of height | Adj in service mode |