Search: philips
Results: 14208
Make Model Symptom Problem Solution By
RADIOLA-PHILIPS 56KV1508
GR1AX
It has a power supply (95v and 9v), but it doesn't start but if we apply 12v to pin 7 of the IC 7020, it works without problems See diode 6523 1n4148, it is open, also change c2636 (9v) piratadoar
PHILIPS 21PT5433/78R
TV turns off next 5 seconds Change capacitor 2455 or transistor 7440 good luck Rovanie
PHILIPS 20PT4331
No sound and vertical closed bottom Replace o eprom Scorpion
PHILIPS 21PT6456
Power supply crying and liver vestibule, 1r 3446 resistor that makes 12v francisco saldanha
PHILIPS 20PT222A - L7L
L7L
Turns off after a few minutes without error Screen adjustment To adjust the screen 1- service mode 062596 + menu, item akb, replace to option 1; 2- put the TV on AV, adjust the screen potentiometer until tsound are no return lines; 3- set the abk option back to 0 Joaquim Andrade
PHILIPS 20GL 1343
It doesn't turn on it doesn't have 70 volts Ts 6345 bf 423 Transistor replaced MATIESKI
PHILIPS 25PT4523/36
S MD1,2E AA
Does not turn on, fuse Na power supply d510 a d513 (1n4007), c2543 c2544 (222k 2kv) joaquim cunha
PHILIPS 20PT3331
Without image, but with characters. 3441 resistor open. Zé Carlos
PHILIPS 14PT3131
Vertical closed at the bottom to the middle of the screen and without sound Epron deprogrammed in my case it was a 1n smd 2641 capacitor that was leaking and deprogrammed the epron renabetu
PHILIPS 29PT4640
L01.1AL
In protection Flyback and shorted oscillator transistor. bc32725 Eli
PHILIPS 29PT785A
G88
Does not turn on, power supply inoperative R3136 = 820k aberto, no pino 3 do ic 7140 BRUSKE
PHILIPS 20PT3331
L03.1L
Vertical closed at the top of the screen C 2465 de 10uf por 160 volts Replace with a 22μF for 160 volts tony eletronica
PHILIPS 21PT5433
Appears character + Ñ has image Check r 3442 of 100k opened or changed in the abl line amsmariano
PHILIPS 14PT418A
L01.2L
Turns on, then turns off, I found that the -13v power supply was missing, as a result of which tsound was no vertical deflection. I also verified that the 05 and 08v power supplys were missing in q 707 and 708. dz 6420 shorted out caused all this confusion. Dz 6420 shorted. Léo, Natal-RN
PHILIPS 42PF7321/78
PLASMA
Off and does not exit stand by mode Sudden variation in AC input voltage When disconnecting the 2 cables from the power supply to the ysus the sound returned. the ysus and the 2 upper and lower bμFfer boards were replaced. image returned to normal Claudio Matulja
PHILIPS 29PT552A
Image with changes in horizontal frequency, small ripples, Capacitor 2448 broken Joacyr Sestrem
PHILIPS FW-C555/19
The sound does not respond to control commands and some panel keys Replace the 100p smd c-2613 and 2608 capacitors, they are located on the front panel next to the (rec) and (auto rev) keys. Rudimar
PHILIPS 29PT5642
Screen closed vertically left See ceramic capacitor 27j, code on the board - 9467 pardalzito
PHILIPS 20PT 3336/78R
When it turned on it was all green and with delay lines and after 5 seconds it turned off Go to the tube socket and check the rgb voltages, everything was ok, I just resoldered the rgb socket and that was it, it was still turning off, I lowered the screen and that was it, tsound was a file heliomar
PHILIPS 21PT5437/78
PT
Vertical closed,oscillating fly back(buzz at) Open resistor 3445. replace and also replace cap.c 2446, as if it leaks it causes the resistor (fusistor) to burn out. ELETRONICA ESTUDIER