Philips Repair Tips
Search: philips
Results: 14251
Results: 14251
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
PHILIPS |
29PT 785A
G88 |
Power supply does not start, inoperative. | Natural wear of the component | Replace 820k resistor, power supply starting resistor. | fernandoferreira |
PHILIPS |
20PT123A
|
Inoperative - does not turn on - when pressing channel the LED flashes several times in a row and remains on | Damaged capacitors, 2551 and 2448 (both 47 x 160v). easy detection - 95v doesn't reach the +b of the flyback, in my case it reached 63v. | Replaced the capacitors mentioned and it's solved. | Tecvideo |
PHILIPS |
21PT5433
|
Turning off for no apparent reason | TRC socket with exhaust, with low volume, I heard a ziiiii...ziiii...ziiii, I disconnected the power cable from the focus and turned on the TV, it didn't turn off anymore, I changed the socket and it resolved. I noticed that the protection is good sensitive. | DJALMA MILAN | |
PHILIPS |
14PT3131
|
Yellow screen and in 5 seconds it turned off and went into protection | The defect was in the first driver transistor of the blue amplifier circuit on the tube board | Dino Cesar | |
PHILIPS |
20PT524/78
|
The TV would turn on after a few minutes, turn off (e.g. 5 to 10 minutes) and turn on again | After changing transistor 7518 (stp6na60); (note: normal measurements) this returned to normal | valter morandini vieira | |
PHILIPS |
14PT8467/78
L03.1 |
Vertical closed and then setup completely reset | Due to high voltage (electrical discharge in the network) | Vertical: replaced resistors 3445,3446,3448, cap.2465 and 2463 vert. opened. I entered service mode. and I adjusted it. The image was normal but without sound, but the audio (carrier) was checked and everything was normal. Conclusion: I replaced the eprom and the audio was normal. | odivaldo araujo |
PHILIPS |
PT5642
|
Did not open vertically | C 2464 and a naughty and very small smd | DEGA | |
PHILIPS |
20PT222A/78
L7L |
Which sai de stand-by | Capacitor (SMD) c2442/220n with cracked solder, resolder | Carlos | |
PHILIPS |
20NC4067
|
Doesn't tune into any channel, it just drizzles | R587 18k open or zener diode 30v d002 shorted | João Victor | |
PHILIPS |
14PT112A/78R
|
Dead | Tsh short. | After replacing the tsh, the TV worked but did not tune. I found a cold solder on the varicap's 8vot line. | Tecvideo |
PHILIPS |
29PT5642
|
Doesn't start | Optical coupler replacement (pc817) | ||
PHILIPS |
FWC 270
|
Display off | D259 shorted. | Carlão | |
PHILIPS |
21PT2663
L7.2E |
Turns on and after a few seconds returns to standby | C2443 without circuit capacity + 13v def. vertical | Raimber | |
PHILIPS |
20PT529A
|
N works 220 | Defective 6523 diode | Replace or even replacement with another 200v | markinho brasil |
PHILIPS |
20PT259A
L01.2L AB-2K2 |
Working perfectly, suddenly, tsound is no video and lines of retraces accompanied by a rumble in the audio and then it turns off. | Ic 7901 (an 7522n) with faults, after the replacement the TV worked perfectly. | Léo, Natal-RN | |
PHILIPS |
14GL1314
|
Tuning was lost (image with drizzle was black and white) and the sound was buzzing | Looking for poorly welded parts, when pressing the tuner the chassis would bend and the image was good | I resoldered the parts in the region wsound the chassis tilted the most (defect resolved) | JOSE CLAUDIO |
TVC PHILIPS |
20PT324A/78R
|
Device on standby starts but when turned on the apparently blurred tube returns to standbay | 1k resistor r2343 on open tube plate | ||
PHILIPS |
20PT3331
|
Disarming or turning off | Scrim | Adjust scrim by pressing volume | |
PHILIPS |
20GL1045
GR1-VA |
Warming up the buk444 | Buk444 burning | Resistor (3321) replaced | Gilberto Antonio |
PHILIPS |
20GL1049
|
Doesn't start | Fly back replacement | Helderson |