Search: philips
Results: 14210
Make Model Symptom Problem Solution By
PHILIPS 29PT4645
LO4U
Device affected by electrical discharge: normal image but no sound. - note: Audio signal present on pins 01 and 09 of the amp. output. Causa: q7991(bc847b) e q7992(idem) Swap them and go for a hug! happiness to everyone. ADHEMAR CAETANO DA SILVA (TECMIL ELETRONICA) NOVA FRIBURGO, RJ
PHILIPS 20PT123 A
LED flashes in sequence and does not start, that is, it does not work. C-2447=680pfx1kv shorted, close to the horizontal output three, and when this happens the 10k r3454 smokes and you also have to change it. Solution was replaced c2447=680pf of 1kv and r3454=10k and it was beautiful. Armando de Olimpia Eletronica EvoluSom
PHILIPS 21PT9467/77
Colored vertical lines at the top of the screen Capacitor 303 1000x25 open diode 302 open d ba158 odilon
PHILIPS FWC505
It turned everything on, but it didn't turn on the panel or the CD drawer came out, nor did it move or remove the optical drive. Well, the panel defect, I checked that the panel was missing negative voltage (-23v), I traced it back to the power supply and discovered the 4.7r resistor r3211 was open, I replaced it, it came back, but the mechanism wasn't, I checked all the voltages, everything was ok, but one of the mechanical drivers, which was not the one in the drawer, was getting very hot, I changed it, if I'm not mistaken, a tda 7370, then I changed the other one, driver 7871, the same number, then everything was ok... I hope I helped someone... hugs R3211 de 4,7r aberto ,driver 7871 SYSTEM ELETRONICA
PHILIPS 29PT5642/78
L04U
Doesn't start. C2411* (near the horizontal exit) *check the table in the schematic for other models of the same chassis Baguatech
PHILIPS FWC270
No sound. and when you unplug it, sound comes out Remove fet from position 7302 and test the sound to see if audio comes out. If Audio goes out, put a new fet Wanderlei Studio - Eletrônica Áudio e Vídeo - Quixadá
PHILIPS 14PT4131
Image moved up Image shifted up, swap transistors 7461 and 7462 Replaced Reginaldo WK Eletrônica
PHILIPS 28GR7580
No tune - no 33v Automatic tuning took a long time and didn't find any channel, the 33v was missing Next to the seletronic, replace open r108. Trendset
PHILIPS 28GR7580
Vertical linearity, partially closed, normalizing when heated Electrolytic capacitors under the power supply board, replace without testing! Trendset
PHILIPS 21PT5435
On and off - screen off with return lines after drizzle R-3450- 27k aberto Replace LUCIANO
PHILIPS HTS3375X/78
Device does not turn on but there is voltage at the power supply The 27v voltage is wrong Cesar Peres
PHILIPS 21PT9467S/78
Cushion effect, closed on both sides about 10 centimeters each. Sometimes I open it and it's normal. Cold solder on q 303. I soldered it and it was ok. Genivaldo
PHILIPS 29PT552
LED power only flashes, power supplys varying C-2575 smd shorted Replace of c-2575, it is between pins 1 and 2 of ic 7581 ALEX/FETTER
PHILIPS 14PT112A
LED flashes quickly 5 to 6 times Flyback s.horizontal Replace LUCIANO
PHILIPS 26PFL3404/78
TPS2.1E
Backlight does not turn on Before accusing traffic, examine voltages of the uba2071 ci see datasheet of the same I replaced the ci and it worked ok ricardoradelsberger
PHILIPS 40PFL3606D/78
L11M1.1L LA
TV does not turn on, power supply inoperative (plhe-p986a) Fh101(250v/5a), c502,u501(ncp1207a), q101(npn), q111(pnp), q501(fqpf6n80c), r517(0,33Ω/2w), d510(uf4007) Replace all these components and the power supply works again. leitemarcellus
PHILIPS 40PFL3606D/78
Inoperative, tv doesn't turn on Capacitor c502 in short circuit on the power supply board. Remove the capacitor and replace it with another with the same characteristics. leitemarcellus
PHILIPS FWM663X/78
FWM663X/78
Stereo--- doesn't turn on anything D15- from the secondary power supply close to c13 and c14 - device voted 100% D15 neupsx4download
PHILIPS 29PT4643
L04L
TV doesn't turn on +LED blinks 5x Transistor reg 5v pos 7605 bc327 fuga darci fuhr
PHILIPS 21PT5435
Turning off in seconds Bc 337 and c 470/ 10 v jandir