Philips Repair Tips
Search: philips
Results: 14210
Results: 14210
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
PHILIPS |
29PT554A/78R
L9.1LAA |
Doesn't start | Capacitor 2450 e 2551(47uf/160v) | Replace the same. | BARRETO CRUZ |
PHILIPS |
29PT554A/78R
L9.1LAA |
Does not turn on LED lights up, when activating power LED flashes and returns to standby. with sound of a mixer working | Kinescope (tube) shorted | Replace the same. | |
PHILIPS |
29PT554A/78R
L9.1LAA |
Doesn't start | Capacitor 2450 e 2551(47uf/160v) | Replace the same. | |
PHILIPS |
20GL1340
GR1 AL |
No reception, just drizzle | 0v on the vhf and uhf pins of the selector (without switching due to +12va being at 11v, and the power supply did not adjust | Trimpot r340 that adjusts the power supply open, oxidized, and also replace r195 of 10r for one of 4r7 | jasvan souza |
PHILIPS |
20GL1340
GR1 AL |
Retrace at the top, like the one caused by the 100mf c410, and without OSD in volume and selection | D410 bax14 shorted | Check d410 | jasvan souza |
PHILIPS |
29PT-4640
|
Flashing image | Measuring the sreem it varies in voltage | Replace o fly back | Ademar / Videira s.c |
PHILIPS |
20PT3331/78
|
Disarming | D - 6445 | Replace the same. | BARRETO CRUZ |
PHILIPS |
20PT4331/78
|
I'm here | Capacitor - 2444 | Replace the same. | BARRETO CRUZ |
PHILIPS |
20PT3331/78
|
Vertical closed | Resistor 3448 | Replace the same. | BARRETO CRUZ |
PHILIPS |
14GL1313
|
Doesn't start | C - 2346/2347(47uf/160v) | Replace the same. | BARRETO CRUZ |
PHILIPS |
14PT3131
|
Generates and cuts giving a vertical symptom | R3491 47k changed | Milton AT-RS | |
PHILIPS |
20PT3336/78
|
TV turns on normally when it turns off it doesn't want to turn on again | Stand by transistor (7541) defective | Replace the same for another. | adriano SB |
PHILIPS |
32PFL3404/78R
TPS2. 1L LA |
Sem backlight | Ic 801 uba2071at with pin 22 short circuited with pin 17 | Replace ic801 (uba2071at) | leitemarcellus |
PHILIPS |
29PT752A/78R
A8 |
Dead | C-2618 (222 x 2kv) and fet-7680 (p16ne06). When changing c2618, when turning on the TV, when the image appeared it turned off as if it were a weak tube. | Swap c-2618 and fet-7680. obs. the fet is on the e61 board, east-west correction. | Tulio / Biguaçu SC |
PHILIPS |
21PT5433/78
LO3 |
Turns on and turns off for no apparent reason | The three bf423 of the tube plate touch directly | jose carlos fonseca | |
PHILIPS |
29 PT4631
|
Normal image, normal sound, with a four-finger dark bar on the left side of the screen from top to bottom and characters pulled to the left!!! | The horizontal exciter circuit of these devices is carried out by a pair of transistors 7461 (bc337-25) and 7463 (bc325-25) in complementary symmetry. Replace these two transistors even if they are measuring as good, as they always show a lack of gain. note the "dash" 25 that corresponds to the hfe of the transistors. As a precaution, also replace the capacitor c2405 between the collector and emitter of the npn 7461 (bc337-25). capacitor c2455 is also critical, due to capacitive reactance at high frequency, so replace it. also check the polarizations of the fet 7400. | Perse | |
PHILIPS |
29PT4631/78
|
TV works normally, then the image goes out and the screen goes completely black. | I replaced the two bc 7461(337) and 7462(327) and the two capacitors 2405(220mf 25v)2455(47mf 25v) change without testing. | ELETRÔNICA MELO BOA VIAGEM-CEARA | |
PHILIPS |
21PT9467C/78
|
Vertical closed, just a stripe at the top of the screen | Diodo byw36, resistor o,68rx2w e flyback bsc29-3807f | After changing it, the TV returned to normal. Note: the byw36 must replace both and observe the flyback if there is a high voltage leak | HIPERELETRONICA SERVICE (MARCELO MARAIAL) |
PHILIPS |
21PT5435/78
|
Not working, just whistles from the power supply | Q7421=but11ax. | Replace for original to avoid return and the +b is 120v and not 95v. | HIPERELETRONICA SERVICE (MARCELO MARAIAL) |
PHILIPS |
VARIOS
|
It does not work via the keyboard or the remote control, and messages appear on the screen | Press 89 and OSD on the remote control | Ademar / Videira sc |