Philips Repair Tips
Search: philips
Results: 14246
Results: 14246
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| PHILIPS |
FL1.16
|
Blank picture. osd not synchronised and too large, no txt. | Check/replace memory ic 7900 (st24c08cb1; 4822 209 32283). | ||
| PHILIPS |
FL1.16
|
Bad picture. picture scrolls. no rc reaction. | +5v was 4,1v instead of 5,1v. replace ic7551 (lm358n; 4822 209 70672) | ||
| PHILIPS |
FL1.16
|
Bad pict. no menu. dark bars over pict. red pict. in dig.scan mode. | +5v was 4,3v instead of 5,1v. ic7551 (lm358n 4822 209 70672) defective. ic7209 (saa7158 4822 209 31059) bendic defective. | ||
| PHILIPS |
FL1.16
|
Bad focus or focus varies in a new set or after crt replacement | Possible solution: short circuit the focus and the g2 pins of the picture tube with the aquadag coating. switch the set on for approximately 5 seconds. after this return the set to its original condition. check if the focus adjusted normally. if not repla | ||
| PHILIPS |
FL1.16
|
Antenna input: no sound. external input: sound o.k. | Check whether crystal 1602 (stereo decoder) 10mhz oscillates. if not replace x1602 (4822 242 80276). | ||
| PHILIPS |
FL1.16
|
Adaption of service information fl93.05 | Adaption of service information fl93.05 --------------------------------------- from 93-06-24 onwards the definition of optioncode 4 has been changed. from this day onwards the definition is as follows: 1 txt peaking filter on/off for lfr box (scandina | ||
| PHILIPS |
FL1.16
|
50hz buzz noticable through speaker | Check/replace ic7680 on the ssp - tda8425, pseudo stereo ic. (4822 209 63734). | ||
| PHILIPS |
FL1.16
|
22av1440 is switched on by external vcr when fl1 is switched off | Connect 4 diodes of type bat 85 to inputs of ic7630 on ssp. 1 diode between pin 3/ic7630 and +5v, cathode to +5v. 1 diode between pin 5/ic7630 and +5v, cathode to +5v. 1 diode between pin 3/ic7630 and -8v, anode to -8v. 1 diode between pin 5/ic7630 and -8 | ||
| PHILIPS |
FL1.16
|
100hz cross | Possible solutions: 1. interrupt on the ssp the 50hz y-signal, between pin 11 position ic7324 (tda4568) and pin 11 position ic7395 (tda8443), by deleting position 4302. repair the connection by means of a shielded cable of 16cm long, m | ||
| PHILIPS |
FL1.16
|
"nvm write protection enabled" message on screen. | Startup problem or 'nvm write protection enabled' message on screen after replacement of nvm (st24c08cb1; 4822 209 32283) with a st24c08cb6 (4822 209 33113). use as replacement the st24c08 1 (9311 021 36682). | ||
| PHILIPS |
FL1.14
|
Wrong synchronization, unstable colors | D6417 on the lsp dependent on temperature, check/replace (4822 130 81223) | ||
| PHILIPS |
FL1.14
|
Wrong service batch of st24c08cb1 memory ic's | Wrong service batch of st24c08cb1 memory ic's 4822 209 32283 ------------------------------------------------------------ temporarily a wrong batch of earom's has been delivered, causing the fault "nvm memory not write protected" after replacing the earom | ||
| PHILIPS |
FL1.14
|
Vertical ripple on picture, and possible error code messages. | The fault was suspected to be in the power supply. on investigation it was found that sops control pcb was heat sensitive. fitting a replacement control pcb (4822 310 31932) cured this fault. | ||
| PHILIPS |
FL1.14
|
Various faults can be observed. | Check the earth connection from the ssp: connect earth tuner with earth line output transformer (lsp) to find-out whether the problem is solved. check connectors l02 and s02 pins 1,2 (sometimes only 7 wires are used in the connector) | ||
| PHILIPS |
FL1.14
|
Unstable picture, horizontal jitter. | Check/replace r3405 on the lsp. (4822 051 10303 for 50 hz sets; 4822 051 10333 for 100 hz sets). | ||
| PHILIPS |
FL1.14
|
Tuning does not function | Resistor r3240 on lsp in v-tuning wire broken. | ||
| PHILIPS |
FL1.14
|
Totally inoperative. | Transistors 7250 (bux85f; 4822 130 62509) and 7251 (bc848; 4822 130 61207) in microsops defective. or d6251 (llz-c5v6; 4822 130 80954) and r1250 (=r3230; 1Ω; 4822 052 10108) defective. or t7270 (bd825; 4822 130 41746) or t7201 (bc857c; 5322 130 427 | ||
| PHILIPS |
FL1.14
|
Total inoperative, leds blinking, error 99 | Check and replace if necessary c2504 and/or 2505 (2kv hrr) on the large signal panel. replace by a 3kv15 hr-r capacitor if possible: 820pf 4822 126 13152 1nf 4822 126 13153 1,2nf 4822 126 13154 1,5nf 4822 126 13155 1,8nf 4822 126 13156 2, | ||
| PHILIPS |
FL1.14
|
Ticking noise and line in picture | Transistor 7381 (bc848c; 5322 130 42136) defective when hot. | ||
| PHILIPS |
FL1.14
|
Synchronization, picture disappears | D6703 and t7704 defective on picture tube panel. |