Samsung Repair Tips
Search: samsung
Results: 3802
Results: 3802
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SAMSUNG |
CHASSIS KS1A
|
No audio and very loud noise | Replacement of c227 next to pin 31 of the ic - 201s | ||
| SAMSUNG |
CHASSIS KS1A
|
Image moved to the side | R414 replacement | ||
| SAMSUNG |
CHASSIS KS1A
|
Uncontrolled power supply, very high voltages | Dz802 replacement | ||
| SAMSUNG |
CHASSIS KS1A
|
Sem vertical | Replacement of c225, next to pin 26 of the microprocessor | ||
| SAMSUNG |
CHASSIS KS1A
|
Noise in sound at + or - 1khz | D602 replacement | ||
| SAMSUNG |
CHASSIS KS1A
|
Constant non-audio noise | Dz607 replacement | ||
| SAMSUNG |
CHASSIS KS1A
|
Start sem ht | R303 replacement | ||
| SAMSUNG |
CHASSIS KS1A
|
No video with feedback lines | R423 replacement | ||
| SAMSUNG |
CB20S10BZ
|
Without image, with osd | R420 120k | ||
| SAMSUNG |
CB-3335Z CHASSIS P69SA
|
Horizontal stripes across the screen. | Leaks on r305 and r308. | ||
| SAMSUNG |
CB5020T CHASSIS SCT11D
|
White screen with vertical colored spots. | 220k r508 replacement on crt board | ||
| SAMSUNG |
CX-5344N, CH S-51
|
It takes a long time for the image to appear after turning on the device | Ic tda6108jf, on the kinescope board, with anomalies | ||
| SAMSUNG |
CHASSIS P69SA
|
Does not come out of standby. | Eeprom 24c02 | ||
| SAMSUNG |
CB 5035Z CHASSIS P69
|
Gives sound. does not give an image. | The cathodes had little emission and the rgb was blocked. I got the kinescope back and everything was normal. | ||
| SAMSUNG |
CB20B30BT -CHASSIS S15A
|
The LED turns on and off. the 8 v voltage on pin 8 of the ic802 does not appear. | Optocoupler pc801 | ||
| SAMSUNG |
CB-5051X CH P68SC-N
|
It turns off with the remote control and turns on again but with an image sometimes with rain and no sound. | Replace q802 (2sc2331) which was leaking | ||
| SAMSUNG |
CB-3351X
|
Image pulled 2 or 3 cm to the left, leaving a black bar on the right | C404 2n7 next to ic101 | ||
| SAMSUNG |
CX-683 - CHASSIS S51
|
Sometimes it doesn't start the horizontal | C407 - 1nf/2kv | ||
| SAMSUNG |
SP47W3HF -RETROPROJECTOR
|
Deconverged image | Icz104 (stk392-040) no convergence module | ||
| SAMSUNG |
CHASSIS S51A
|
Image with poor quality, the voltage of the g2 has a maximum value of 300v | Happened to crt thomson. the solution starts by replacing the transformer lines, 300v is very little, it should have a maximum value of 650v |