Samsung Repair Tips
Search: samsung
Results: 3847
Results: 3847
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SAMSUNG |
SYNCMASTER 3NE -CQB4147
|
Normal controls, but the width is smaller than normal | Replacing capacitor c422, or other capacitors associated with the collector of the horizontal output transistor | ||
| SAMSUNG |
SYNCMASTER 3NE -CVM4967P
|
Power supply does not start, or works after several attempts. | Replace c621, c619 | ||
| SAMSUNG |
753V
|
Insufficient width | Q419 | ||
| MONITOR SAMSUNG |
551V -PN15VS
|
Retrace line and dot in the center of the screen when turning off | C101 (102k/500v) na placa do trc. | ||
| SAMSUNG |
CN3383
|
TV doesn't turn on and the LED is off. the +b of 130, 15 and 5vdc ok. It doesn't activate the stand-by and it doesn't have the 9v that powers the computer. defect | The bad crystal. | ||
| SAMSUNG |
CB5035Z
|
Stuck in osd mode, no functions | Change the eprom, check that the earthing of the green cable running from tuner is ok | ||
| SAMSUNG |
CB5020 P58SC
|
Tuning not stopping | Replace r116 120kΩ this was open circuit | ||
| SAMSUNG |
CX5012
|
Volume low, even at maximum setting | Replaced ic601 tc4066bp close to if can | ||
| SAMSUNG |
CS3339Z
|
No picture no sound | Faulty ic tda6107q on crt board | ||
| SAMSUNG |
CW28C33N
|
Dead. in safety mode | Looks like l.o.p.t but was traced to small decoupling cap on 200v line on tube base, dead short | ||
| SAMSUNG |
CK-5320ZR SCT11D
|
Field collapse | Check r410 1Ω in feed to d403 for o/c | ||
| SAMSUNG |
CB7230WT
|
Vertical output problems, vertical output ic fails repeatedly ! | Fit a new ic, clean old heatsink compound, add fresh compound thinly on the surface. now disregard all the other modifications previously suggested and add a large heat sink on the existing heatsink screw another one on top | ||
| SAMSUNG |
TXG2547 K51A
|
No power, voltage not changing on pin 18 ic901 szm-368et2 | Check dz906 short, key-in 1 pin 9 of ic901 | ||
| SAMSUNG |
CB5012Z P58SC
|
No colour, stuck on secam only | Check r514 100k open circuit or very high value | ||
| SAMSUNG |
CB5012Z P58SC
|
Stuck in secam mode | Change resistor r514 100k | ||
| SAMSUNG |
TV-VID COMBI MODEL: TVP-3350IS SVC11C
|
Set stuck in standby mode | Check for failure of q801 strs6707 | ||
| SAMSUNG |
TV-VID COMBI MODEL: TVP-3350IS SCV11C
|
No rf audio - ok on vcr tape playback and via scart input | Hairline cracks in pcb tracks on motherboard directly at the back of the tuner | ||
| SAMSUNG |
W124W6VN
|
Picture darkens and lightens continually | This was due to a faulty first anode potentiometer, as its part of the l.o.p transformer a new l.o.p.t had to be fitted | ||
| SAMSUNG |
TXB1940
|
Red led blinks on / off, tv does not turn via power button and/or remote but after 20 minutes or so it turns on and works fine | Replace r902, r901, r905, r903, r900a, q902, and possibly the two one small and one large capacitors in the section labeled as the power supply. the board will be black under the components that are bad. q902 is an npn transistor and is hard to find. | ||
| SAMSUNG |
SV-2303 SV633
|
Intermittent functions | Check for dry joints on mode switch and clean off any grease inside the switch |