Samsung Repair Tips
Search: samsung
Results: 3847
Results: 3847
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
SAMSUNG |
WS-32A116V CH. K55A-1
|
The TV turns on and off cyclically, the image sometimes appears, like a flash. | Replace diode d904 (rb441q), it was shorted. | ||
SAMSUNG |
CX-6844N
|
All voltages at the power supply output sometimes dropped by around 20%, leaving the image with little horizontal deflection. | Replacement for the 15v dz805, this one with a very small leak. | ||
SAMSUNG |
CB-5051A SHASSI: P68SA
|
Closed vertical and short on the sides | Q-806 ksc2331, +8v low voltage. | ||
SAMSUNG |
CB-3373T CHASSI S15A
|
Doesn't work | Check the power supply and output voltages and see if the 125v voltage is being lowered see tsh disconnect the line transformer pin or h_out and see if it normalizes and change the 271k 2kv c410 capacitor | ||
SAMSUNG |
WS-32W6HA CH. SCT53A
|
It starts with high voltage, but we only have video when the channel is changed, noticing that a color is missing. | The 82k r511 resistor was replaced on the socket board. | ||
SAMSUNG |
CX5944N CHASSIS SCT12B
|
LED always yellow, +b voltage around 70v, without mat | R812 (27r) open, connects to the q802 emitter | ||
SAMSUNG |
CX-6844N CHASSIS S51A-AA41
|
The TV doesn't start with HT, the LED keeps flashing and the +b has around 200v | Had the r815 changed in the photocoupler circuit | ||
SAMSUNG |
CX-3318 CHASSI P58SC
|
Reduced image height | R308/18k | ||
SAMSUNG |
WS-32Z316V
|
Image all green. | R511, 542, 543, 506, 544, 510, all 160k, located on the crt plate, were replaced. | ||
SAMSUNG |
SP-436J6HD
|
The image appears horizontally out of phase and has the power, lamp and standby LEDs on. | There was a problem with the ic - saa1300 on the main board. | ||
SAMSUNG |
WS-28Z44V--CHASSI KS3A
|
We are east-west | R 425 amended | ||
SAMSUNG |
5012T
|
Super slow tuning | R 705 | ||
SAMSUNG |
CHASSIS S15
|
Reduced vertical with out-of-focus plot | C248 | ||
SAMSUNG |
CX5944 CHASSI SCT12B
|
Voltage too high, it goes into protection. | Ic803 | ||
SAMSUNG |
CX7039NP CH Z70
|
Comes out of standby, but there is no high voltage. | Had c458 of 220nf 400v disabled | ||
SAMSUNG |
CB5073Z CHASSIS SCT11D-05
|
Image with horizontal lines and when you change programs and the TV mutes the video, it has green lines like return lines | Replace r306 (open) | ||
SAMSUNG |
CX533CN CHASSI S51A
|
It doesn't tune, even though the OSD looks like it does. tuning voltage does not change. | C901 150pf ceramic, close to terminal 1 of IC saa5297ps/238 | ||
SAMSUNG |
TVP3350X CHASSIS SCV11B-00
|
It works for a few seconds, then the 125v changes to 88v and there is no longer high voltage, but it does not go into standby. | 68uf 100v c823 replacement. | ||
SAMSUNG |
CHASSIS P68SA
|
After repairing the power supply, the +b 125v still did not adjust. | 100uf 160v c853 replacement. | ||
SAMSUNG |
CB-20S20BT
|
TV did not turn on (turned on) the secondary voltages were all correct except the 125 volt one which had 152 volts | Photo-coupler pc-123 |