Samsung Repair Tips

Search: samsung
Results: 3801

Make	Model	Symptom	Problem	Solution	By
SAMSUNG	T22B300	TV completely turned off	It was running, it made a few clicks and stopped.	Changing the icm801 str w6052s, cm804, dm801 and dm803 and the TV started working again.	Manoel Damião
SAMSUNG PLASMA	PL50C450B1	TV turns on with logon sound but no image appears.	Short or leak in capacitors c2096/c2097 (near the flat that connects the main board).	Replace tcon board	Joaquim Santana
SAMSUNG	UN32F5500AG BN44-00605A	TV turns on with all functions but the LEDs do not light up	A burned out LED on the LED bar (replace the LED or the bar), after the change the LEDs still do not light up: zd9101 (y8w/39) open on the power supply board, remove from another scrap board		George Luís
SAMSUNG	UN32F5500AG BN44-00605A BN44-00605A	TV turns on with all functions but the LEDs do not light up	A burned out LED on the LED bar (replace the LED or the bar), after the change the LEDs still do not light up: zd9101 (y8w/39) open on the power supply board, remove from another scrap board		George Luís
SAMSUNG	T24B301LB	Does not turn on, short circuit on the 3.3v line, in the 25q40 flash memory (ic1302) tsound was a lack of 3.3v, short to ground.	Ic 202 (1g) changed damaged the ic 1201 smd (nt61p805)... went to change and run for hug....	Ic202 e ic1201	MIGUELTV
SAMSUNG	T200M	It works for about 5 minutes and turns off the screen and tsound is only audio	Lack of 5v on pin 1 of the fan7317	Jump pin 18 enable to pin 1 of the fan7317 and the lamps are on	Beto2828
SAMSUNG	T200M	It works for about 5 minutes and turns off the screen and tsound is only audio	Lack of 5v on pin 1 of the fan7317		Beto2828
SAMSUNG	UN32FH4205	Red standby,ic205 warming up	Short in capacitor c932 main board, every line has a short, it could happen that another capacitor has a defect, tsound are many in parallel.	Replace the capacitor	Macro eletronica
SAMSUNG	UN55JU6000G	Does not turn on, nor does the standby LED light up	13v low voltage, with 3v approx.	Cold solder on transformer terminals	Junior - Tecnoprom
SAMSUNG	CL21K40MQ	Dark dull screen with cannon filament accessed with channel sound	Kinescope in short killed scrim attention	I replaced the kinescope and the TV was good again	Biel eletrônica
SAMSUNG	UN46F6400	Turn on and off	Caindo 5v standby , replace capacitor cs802 10uf x 50v		TV CENTER GUAIBA
SAMSUNG	UN40FH5303 BN91-11598T	Inoperative does not even light the by	Bad transistor on main board. ic1204 or ici204	I tested the power supply and it was ok, I went to the main board and found this regulator traffic bad. close and connected to the reset key on the main board	Fernando Nascimento
SAMSUNG	UM40FH5303 BN91-11598T BN91-11598T	Inoperative does not even light the by	Bad transistor on main board. ic1204 or ici204	I tested the power supply and it was ok, I went to the main board and found this regulator traffic bad. close and connected to the reset key on the main board	Fernando Nascimento
SAMSUNG	UN40EH5000G BN91-08831M BN91-08831M	Doesn't start	Ic202 na placa principal	Replace ci 202	Bolivar & Flávio BF eletrônica
SAMSUNG	CL29Z50MQ	Turns on without image, black screen, enlarges the screen, retrace lines appear,	Replace zener diode dz201.5v6 near micronas		djpituka
SAMSUNG	UN32FH4003G	TV with standby LED off	Shorted dm858 diode	Resolder power supply board	Eletrônica Telecom
SAMSUNG	UN43RU7100G	Red LED flashing, TV won't turn on.	One of the capacitors in set r, which is located under the processor heatsink.	Check if tsound is a voltage of 3.3v on pin 8 of the ic1603 memory, if tsound is no voltage, check if this line is shorted	Reinaldo
SAMSUNG	UN75H6300A	Turns on, with sound, no image, buses do not light up	Shorted capacitor on the tcon, tsound is no silkscreen marking, this capacitor is in front of the qd11 regulator	Replace..	Maurilio
SAMSUNG	T22B310LB	Does not turn on/standby off	Ic1601/54328 shorted and the diode (zd 2) on the power plate with cold soldering	I replaced the ci 54328 and the short disappeared, but the LED didn't light up, I checked that the zd2 diode on the plate next to the connector was continuous in both directions with a resistance of 156Ω. I removed it and put it back and it returned to normal.
SAMSUNG	T22B310	Does not turn on/standby off	IC 54328 shorted and the zener diode on the power plate with cold soldering	I replaced the ci 54328 and the short disappeared, but the LED didn't sell, I checked that the diode on the plate next to the connector was continuous in both semicircuits with a resistance of 156Ω and I removed the post back and it returned to normal	Edselmo