☰

Samsung Repair Tips




AIWA
BEKO
CCE
CINERAL
DAEWOO
FUNAI
GRADIENTE
GRUNDIG
HITACHI
ITT
JVC
LG
MITSUBISHI
PANASONIC
PHILCO
PHILIPS
PIONEER
RCA
SAMSUNG
SANYO
SHARP
SONY
THOMSON
TOSHIBA
VESTEL


Search: samsung
Results: 3801
Make Model Symptom Problem Solution By
SAMSUNG UE32EH4003
Nothing lights up Dead power supply Failure in diode dmb07c (sb5150) at the power supply Alex
SAMSUNG UN40J5200AG
LEDs do not light up. Open leds. open fuses. bars coming into contact with the chassis. Replace LEDs and fuses. isolate chassis bars. reduce inverter voltage (traditional 3~5w resistors r9163 and r9164 of 2.3Ω in parallel. the higher the resistance of the set, the lower the voltage. Erick
SAMSUNG UN40J5200AG
LEDs don't light up LED bar fuse open. LED open. LED bar shorting out to chassis 1. replace LEDs and fuses. 2. isolate chassis bars Erick
SAMSUNG LE32A336J1D
Blinks twice but doesn't turn on Memory k4d261638klc40 Replace for new Edson SP
SAMSUNG UN55B7000
Stand-by LED flashing, but works normally It was solved by changing the two sensor boards (touch and remote)
SAMSUNG UN46D5500
Turning off Main board
SAMSUNG UN46C5000
Lists in the image Cleaning the lvds cable and connector
SAMSUNG UN40F5500AG
The LED kept flashing but it doesn't turn on. She stopped on a day with lots of lightning. Icm851 ( 43a ) shorted.
SAMSUNG UN40F5500A
The LED flashes 5 times in batches of 2 flashes and repeats Power supply board
SAMSUNG UN40F5500A
LED flashes 5 batches of 2 times Open led
SAMSUNG UN40F5500
Turning off after five minutes. had normal sound and image and performed all the functions Main_unit
SAMSUNG UN40D5500RG
Restarts itself constantly Main board. corrupt firmware.
SAMSUNG UN40D5500RG
When turned on, it turns off the screen and then turns on by itself and stays on and off Main board
SAMSUNG UN40D5500
The Samsung Smart logo appears and turns off. Main board. the 5500 board = the 5000 board.
SAMSUNG UN40D5500
When turning on, a glow would appear on the screen and it would go off shortly afterwards. everything ok with the power supply. Open fuse on t_com board
SAMSUNG UN40D5000PGXZD
Clicking noises during operation! Insulating tape was placed between the rear cabinet and the LED panel.
SAMSUNG UN40C5000QM
Does not come out of stand by Dp803 shorted
SAMSUNG UN32F5200AG
It doesn't turn on and stays on standby blinking. the pfc is low (280v). LED panel connector with sunken pin. I didn't give enough contact.
SAMSUNG UN32F4200
Dark screen Fet d3n4 and open leds
SAMSUNG UN32EH5000G
Doesn't start Hand plate