Sharp Repair Tips

Search: sharp
Results: 1789

Make	Model	Symptom	Problem	Solution	By
TVC-SHARP	C-2188 B	Image stretched vertically and shaking in the same direction	Ic 501 (la 7837) vertical exit		Adhemar Caetano da Silva
SHARP	C-2013	Sem video e osd	Flake d601	Replace d 601 1in4148	joaomvjr
SHARP	21LT45S 11AK44	Does not turn on LED turns red and green when trying to start	Problems with the power supply integrated circuit	Replace the integrated one and the electrolytic capacitor	ALACYTE
SHARP	C-20S02	It doesn't turn on, when trying to turn it on it made a small noise like a light tap on the glass and stopped!	It was just 8200pf wide 616 capacitor.		pfa
TV SHARP	C2092B	Vertical anormal	Causa c 510 1000/50v	Image with bar and non-standard linearity	ELETRONICA ROCHA FERNANDO ROCHA
TV SHARP	14RS03	Immediately shorting the d706 z130v	R707 33k, opened or modified..		MOURA
SHARP	14R12	Dead	Microprocessor	Hey guys, this tip is important, if the voltages are ok, with the TV plugged in, close a permanent cut between pins 41 and 42 on the computer, if the TV turns on, you can replace it.	RAIO INFOSERVISE-SP
SHARP	C2013	Noise at the power supply, TV works normally but with noise.	C735 replace		DEBIQUE(ELETRONICA ROBSON)
SHARP	C1453	Totally inoperative, normal supply all voltages present (+115v, +14v, +12v)	R717 (22k/ 1/2 w - 1%) altered.	Attention: this resistor is critical so do not try to reuse a scrap one, use a new one and if possible with a 1% tolerance.	Altevir Lima (Valparaíso Eletrônica/PA)
SHARP	C2053	It turns off after + - 1 minute and only turns on again if you remove it from the socket, with the intervals getting shorter until it no longer turns on.	Zener diode dz606 (22 volts) with leakage.	Tsound is no point in testing because the test appears to be normal, replace directly.	Altevir Lima (Valparaíso Eletrônica/PA)
SHARP	1413 OU 2013	TV turns on and does not obey functions, only accepts power command,	"ic 201 chroma and luminance processor", the tda 8360 does not execute the commands it receives from the computer, note, to make sure that the problem is not in the computer, measure pin two of ic 101, use a 10 volt dc scale, increase and turn down the volume and see if the voltage varies if the computer is ok.	Replace o ic 201 tda 8360	Ricardo Alves- Eletrônica do Ricardo - Caté MG
SHARP	C2041B	Vertical closing at the bottom	C507 downloaded	Replace o capacitor 1000/35v	joao gama
SHARP	2082	Tsound was only sound on AV channels, tsound was no sound at all	Just replace c311/ 103 k resolved hugs to all friends		EURIPEDES
SHARP	2082	Tsound was only sound on AV channels, tsound was no sound at all	Just replace c311/ 103 k resolved hugs to all friends		EURIPEDES CAETANO FILHO
SHARP	C 1453 OU 2053	Exhaust. tall, white screen with lines.	Flay b. e o d601 em curto (in4151 ou in4148)	I replaced the fb, and the diode.	This email address is being protected from spambots. You need JavaScript enabled to view it.
SHARP	C14 RS03/20T51/14S02/14RS02/C14R12	Stopped, with 115.5 vdc present but does not start	Reg. 9v screwed, d706 shorted and ic703 reg 115v	I just replaced them and everything was fine	This email address is being protected from spambots. You need JavaScript enabled to view it. Espirito santo
SHARP	C2038	Horizontal bar (bands on the side, corner of the screen)	Replace it	C611, 560n - 250v	This email address is being protected from spambots. You need JavaScript enabled to view it.
SHARP	C1438	Does not oscillate, tick-tick	C 607-820pf - 1kv and c621- 1k- 1kv both shorted and leaked		This email address is being protected from spambots. You need JavaScript enabled to view it.
SHARP	C 1453	No characters	R653- 22k		This email address is being protected from spambots. You need JavaScript enabled to view it.
SHARP	20R12 04.13.0074.05-7	Contrast acts on the characters, not on the image (blurry image)	Resistor r430- 680k smd		This email address is being protected from spambots. You need JavaScript enabled to view it.