Search: sharp
Results: 1789
Make Model Symptom Problem Solution By
SHARP C - 2017
White lines at the top of the image C - 657 = 1000uf x 35v FERNANDO S
SHARP C-1485
Power supply beeping and won't turn on C 607 shorted ARAUJO
SHARP TVC 1413/2013
Replace Altered capacitor 712, 39 nano Replace Tectoy
SHARP TVC 1413/2013
Power supply does not weapon Resistor rx717 Replace Tectoy
SHARP C1457B E C2057B
Weak contrast and brightness takes time to appear Capacitor 624 spacious Replace Tectoy
SHARP C1457B E C2057B
Vertical missing at the bottom 1Ω r718 with changed value Replace Tectoy
SHARP C-1453
Does not turn on (arming protection) If it connects without the vertical output, in addition to changing the d603 Bruno
SHARP C-2053
Does not turn on (arming protection) Remove the vertical output ic501 If it connects without the vertical output, in addition to changing the d603 Bruno
SHARP C-20ST58
Turn off after turn on R 505 open This email address is being protected from spambots. You need JavaScript enabled to view it.
SHARP C-1417
Stop Replace c 719 This email address is being protected from spambots. You need JavaScript enabled to view it.
SHARP C-20ST57
Without image, enlarging the without the image appears but bad C 624 exhausted on the +b of the filament Bruske
SHARP C-20R11
Inoperative, normal voltages, minus the 9 volts that come out of the vertical Zener diode (dz660) shorted This email address is being protected from spambots. You need JavaScript enabled to view it.
SHARP C2041
No contrast. Disconnect pin 3 of the computer. Just that. This email address is being protected from spambots. You need JavaScript enabled to view it.(floripaSC)
SHARP C2038
Keys stuck without menu does not enter service mode R235 from 27k no pine 40do tda8841 altered RUBENSSO2000
SHARP C2999
Stk73908 getting very hot D7006 short betoteck
SHARP C - 2082 B
Power supply beeping with low voltage C - 607 = 560 pf FERNANDO S
SHARP C20ST58
Turns on normally notice a dark band on the right side of the screen and then turns off Capacitor c606 of 7n5 for 1600v Replace c606 ze nascimento
SHARP C-2030
Doesn't work heats up r604 2k7 Saida vertical ic501 tda8356 To switch off Badri
SHARP 54DT25S
Does not start R705(560k) Grobio
SHARP 37EM-33S
Horizontal line at the top of the screen Pin five of i.c.501 open. onil