Sharp Repair Tips

Search: sharp
Results: 1789

Make	Model	Symptom	Problem	Solution	By
SHARP	C-14R12	Slipping away from the tune	R203 270k changing		paulo-maceio/al
SHARP	C-2057	Pulsating, kills power supply	Capacitor c 607 (681pf) 1,6kv	Shorted	arasonic
SHARP	TV 20ST 58	Arming the protection for no apparent reason and it only turns on if you unplug it and turn it on again	Arming the protection for no apparent reason and it only turns on again if you remove the cable from the socket and turn it on again		jorge a silva
SHARP	C - 14R12	Vertical closed	Voltage of pin 3 of the vertical ic with 15v. the right one is 24v	D 501 with leak. Don't measure, replace.	FERNANDO S
SHARP	C-1413	Activating the protection without apparent cause.	Diode d104 shorted on pin 19 of ic 101.		alexsts
SHARP	20R11	Doesn't start,	It doesn't have 115v.	Obs: information remove l731 and place a 560r x 20w resistor on d731 to ground, disconnect r652 and r331, check the 115v on d731 if the power supply is normal.	nick
SHARP	20R11	Doesn't start	Ic 201 la7685 shorted pins 34,35 and 36.		nick
SHARP	C20RS03	Vertical closed at the bottom	C 506 amended		flavio
SHARP	C2082B	Disarming	C613 (1mf x 100v)		Persio (TVCOMPANY)
SHARP	C-2092	Burns tsh after two days of use	C 719 10/160v exhausted		ARAUJO
CALCULADORA SHARP	EL1810PLLL	Dial connects all digits	Dirt on the power supply PCI	Do a general cleaning	eletronicaapolo
SHARP	TVC 20S01 /20R11 CR.	Clear screen with retrace lines.	Lei 806 =6.8uh cut and also check that 806.	In my case I just replaced the coil and it was fine.	Armando da Eletrônica só Tv.
SHARP	C14T51 / C20T51 E C14 R 12.	Light point in the center of the screen when turning off.	Causa capacitor c-730=150uf por 25v.	At Sharp's request, just remove the capacitor.	Armando da Eletrônica só Tv.
SHARP	C 2041	No contrast	Chap. ceramic 808 w/ joint		DEBIQUE ( ELETRONICA ROBSON)
SHARP	C2038	Stop	Shorted capacitor	Replace cap 607 and cap 627 and put a 2n2 for 1kv in place of both, run for a hug	fernando timbauba PE
SHARP	C-14ST57	Stop	Shorted capacitor	Replace cap 607	fernando timbauba PE
SHARP	51AM-12S 5BS-A	Upper non-vertical stripe	Q509 - bc338	Replace q509	jose luis calcada
SHARP	51AM-12S 5BS-A	Colored return lines, sm picture	-10v supply vertically, with -8v	Replace c713 - 1000μF and q510 - bc338	jose luis calcada
SHARP	C 2053	Won't turn on - 12v missing	R 731 open	Replaced the resistor, the problem was solved	Luiz
SHARP	C2095-B ?	Does not start with noise on the fly back, giving the impression that it is the fly back	Change power supply, in this case the ceramic capacitor c720-10n		guma