Sharp Repair Tips
Search: sharp
Results: 1784
Results: 1784
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SHARP |
20ST58
|
Alloy 115 c 75v check c725 and 727 47/160v usually burst and lose capacitance | Changed and resolved | Eronaldo | |
| SHARP |
TV 2053
|
Vertical stretched | Dodo zener ic- 104 33 volts aberto | jaironuness | |
| SHARP |
TV C 2038
|
Vertical closed | Changed the vertical outlet tda8356 and r 505 33 homs | jaironuness | |
| SHARP |
2017
|
Closed horizontal | C 617 ( 560 p / 250v ) | JOHN | |
| SHARP |
1453
|
Dead | Trafo drive | Replaced the same TV that worked normally | filipak |
| SHARP |
C2082
|
Does not fully open the vertical strip on both sides of 10 cm at the bottom and top | Change c 507 1000 / 35 volts weak. | jaironuness | |
| SHARP |
C-2053
|
Vertical stretched | Ic104 aberto (diodo zener 33v) | Replace ic104 | ric |
| SHARP |
C20R11
|
Turns on after a few seconds turns off | Unbelievable 33v zener shorted killing the 115v plus b line | Replace do zener 33v (ic 1005) | VAGNER NARDES |
| SHARP |
C1467 B
|
It turns on sometimes, always after it is hot, with all voltages at the power supply | Bu2508dx with leakage (replace without measuring) and c616 with leakage (6n8/1600v) | vagnernardes | |
| SHARP |
1453
|
Tune in all channels except 4 | It was memory. I removed the blessed one, turned on the TV and then put it back and bingo the blessed one came back 4 hugs to everyone | Talmid | |
| SHARP |
C- 2038
|
Doesn't turn on (power supply keeps trying to start) | C607 with leak | Capacitor replaced | Ivan |
| SHARP |
C-1692B
|
Horizontal line, in the center of the screen. | If not s.vert, subst. tda8305a pin 3 voltage-free drive. | LUIR FRANK | |
| TV SHARP |
C2038
|
Tsound is no image | Without power supply | Capacitor c621 shorted | josuel barreto |
| SHARP |
1440B
|
After a few seconds the TV turns off by itself, when you lower the screen it looks fine. | Open contrast trimpot (100k). | luciano fontes de souza | |
| SHARP |
20R12
|
Turns off by itself | I removed the 658 diode | marcos | |
| SHARP |
C-2OR12
|
Turning off when. puts the'antenna signal when. Tsound is no signal, the TV won't turn off | Turn off 0 d-658 near the flay back | ||
| SHARP |
C20R12
|
Retraction, no picture normal sound | Lack of y(luminance) us draiv rgb | Open resistor r 824 | DEBIQUE |
| SHARP |
37EM33S
CA-1 |
Locked no child lock | You must enter service mode (with TV off on power, press vol- and ch+ on TV and turn on power). select > nvm > 4d > password on > enter w/ r/c (0) to unlock; exit to menu on the ground floor. | jose luis calcada | |
| SHARP |
TVC20R12 / 20RS02/03 20S02
|
Without contrast and protection acting | R675 of 5k6 connected to pin 10 of the open flay back | R675 replacement | |
| SHARP |
27HS60
|
Horizontal exit burn | Ci do vertical short | laurindo |