Sharp Repair Tips

Search: sharp
Results: 1789

Make	Model	Symptom	Problem	Solution	By
SHARP	C-20ST58	Turn off after turn on	R 505 open		This email address is being protected from spambots. You need JavaScript enabled to view it.
SHARP	C-1417	Stop	Exchange c 719		This email address is being protected from spambots. You need JavaScript enabled to view it.
SHARP	C-20ST57	Without image, enlarging the without the image appears but bad	C 624 exhausted on the +b of the filament		Bruske
SHARP	C-20R11	Inoperative, normal voltages, minus the 9 volts that come out of the vertical	Zener diode (dz660) shorted		This email address is being protected from spambots. You need JavaScript enabled to view it.
SHARP	C2041	No contrast.	Disconnect pin 3 of the computer.	Just that.	This email address is being protected from spambots. You need JavaScript enabled to view it.(floripaSC)
SHARP	C2038	Keys stuck without menu does not enter service mode	R235 from 27k no pine 40do tda8841 altered		RUBENSSO2000
SHARP	C2999	Stk73908 getting very hot	D7006 short		betoteck
SHARP	C - 2082 B	Power supply beeping with low voltage	C - 607 = 560 pf		FERNANDO S
SHARP	C20ST58	Turns on normally notice a dark band on the right side of the screen and then turns off	Capacitor c606 of 7n5 for 1600v	Replace c606	ze nascimento
SHARP	C-2030	Doesn't work heats up r604 2k7	Saida vertical ic501 tda8356	To switch off	Badri
SHARP	54DT25S	Does not start	R705(560k)		Grobio
SHARP	37EM-33S	Horizontal line at the top of the screen	Pin five of i.c.501 open.		onil
SHARP	C-14R12	Slipping away from the tune	R203 270k changing		paulo-maceio/al
SHARP	C-2057	Pulsating, kills power supply	Capacitor c 607 (681pf) 1,6kv	Shorted	arasonic
SHARP	TV 20ST 58	Arming the protection for no apparent reason and it only turns on if you unplug it and turn it on again	Arming the protection for no apparent reason and it only turns on again if you remove the cable from the socket and turn it on again		jorge a silva
SHARP	C - 14R12	Vertical closed	Voltage of pin 3 of the vertical ic with 15v. the right one is 24v	D 501 with leak. Don't measure, replace.	FERNANDO S
SHARP	C-1413	Activating the protection without apparent cause.	Diode d104 shorted on pin 19 of ic 101.		alexsts
SHARP	20R11	Doesn't start,	It doesn't have 115v.	Obs: information remove l731 and place a 560r x 20w resistor on d731 to ground, disconnect r652 and r331, check the 115v on d731 if the power supply is normal.	nick
SHARP	20R11	Doesn't start	Ic 201 la7685 shorted pins 34,35 and 36.		nick
SHARP	C20RS03	Vertical closed at the bottom	C 506 amended		flavio