Sharp Repair Tips
Search: sharp
Results: 1784
Results: 1784
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SHARP |
37AM23H 5BSA
|
Service mode adjustments | Hold vol up, vol down and chin up buttons while switching on | ||
| SHARP |
37AM-23H
|
Nvm corrupt | Replace ic1002 & reprog nvm | ||
| SHARP |
37AM23H
|
To enter service mode | Press & hold front '+p' & '-v' keys whilst sw on - note hex settings b4 adj. to exit menu just sw off tv.select with chan +,- ; adj with vol +,- | ||
| SHARP |
37AM23H
|
No tuning & osd almost off screen | Nvm chip ic1002 | ||
| SHARP |
37AM23H
|
Dead - ht only 40v at loptr coll & whining | R704/5 560k | ||
| SHARP |
37AM23H
|
Corrupt nvm - osd is off to right of screen | Replace eeprom available from wve £5 & adj elect screwdriver | ||
| SHARP |
37AM23H
|
Child lock removal - pin no not known | Press vol - on tv & child lock on remote together , press mode on rem, using channel +/- to select child lock , select new pin press mode , e. | ||
| SHARP |
37AM23H
|
Child lock on , pin not known . | Press vol - on tv & child lock on remote together , press mode on rem using channel +/- to select child lock , press mode , e | ||
| SHARP |
37AM23
|
No green - eeprom corrupted | Replace q708 & q704 bc338-40 in psu & c716 220µ 10v | ||
| SHARP |
37AM12S
|
Service menu to access service mode | Power off at switch hold -volume & +ch & turn set on switch (set should be service mode) press ch+ until nvm (last service setting) now use volume control on remote change top (red) setting to "c5" now press "0" on the remote now put set into standby now turn set of at switch the set should now be able to be tuned in | ||
| SHARP |
37AM12H
|
Poor pic/sound - noisy | Unable to get correct results in service mode - nvm pt no ch-ix1463cjhc | ||
| SHARP |
28HW53H DA50W
|
Blurred pic | C1815 100nfd sm device leaky, dragging 12 volts down to ic1801 on crt base | ||
| SHARP |
22DS03H
|
Field - only half a scan | Check fuses f601 & 602 2.5a | ||
| SHARP |
21LV1
|
Dead | Chopper tr 2sd1884, d706 rg2 & loptr leaky | ||
| SHARP |
15AT15H
|
3 coloured lines on the top of the picture | Replace d504 (measured ok). i used 1n4005 as a replacement. | ||
| SHARP |
14B
|
St/by only | Vid proc ic801 tda8362 u/s - line osc section dead | ||
| SHARP |
12P-41H
|
No pic - crt htrs lit - no eht | Loptx | ||
| SHARP |
2013
|
No Sound | Capacitor 310 connected to pin 1 of ci201(tda8360) | ||
| SHARP |
C-20R12
|
No characters | Coil 1004 open on pin 27 of the micro | ||
| SHARP |
C-2188B
|
No characters | R1047 33k open |