Search: sharp
Results: 1784
Make Model Symptom Problem Solution By
SHARP TVC 1631B
Just drizzle on the screen and no volume control The drizzle was resolved by replacing the resistors, all open, r-217 6k8 r-227 2k2 r-215 47k ic-202 33v zener, the problem of the loud and uncontrolled sound was resolved by replacing the leaky transistor q 1208 bc547b
SHARP SHARP 2013
Doesn't start Today he is not a monitor. Today's is a sharp that had all the voltages, had sound but didn't oscillate horizontally. I realized that it had audio because the power comes from the power supply and this was fine. the problem was the q701 without a base. I just had to change it and the problem was solved, ok? ps. Be careful, this TV also won't turn on if the vertical power supply is bad. When you experience this problem, turn off the vertical power supply to see if it turns on. tip sent by: laureano
SHARP C-20R11
Works but without menu and osd characters Replace capacitor c 1037 on pin 29 line of ic 1001
SHARP C-2003
Image closing vertically suddenly and horizontally rarely: R604
SHARP C-2003
Dull, high voltage and no sound: Zd201 is r734
SHARP C-2003
Vertical scratch on the screen, r633 getting hot and normal sound: C618, c619 e t502
SHARP C-2003
Without sound, image, high voltage and with horizontal oscillation: Rataaaaaaaaaaaaaaaa
SHARP C-2003
Just a horizontal line on the screen: Q504, q505 e r636.
SHARP C-2003
Closed vertical: Q 504 e q505
SHARP C-2003
No glow, filament lit and with sound: Rataaaaaaaaaaaaaaaa
SHARP C-2003
Image in the form of glasses: T 502
SHARP C-20ST57
Vertical closed Ic203 diodo zener 33v
SHARP C-20ST57
Takes time to enter image, dark screen C-803
SHARP C-29ST54
Burns horizontal output Shorted vertical ic and power diode
SHARP 29ST58
Doesn't start Q602 ou ic 2101
SHARP 20LC20
Does not light (dead) Transistor q752 2sc3866 crossed by short circuit of transformer t752.
SHARP 21LG30
Does not light 1. ic751 (stk73907-t) in short circuit 2. c762 of 22pf - c760 of 33pf.
SHARP C-2188B
TV completely inoperative. Good fuse. Voltage at the rectifier output. No voltage at the power supply output. drain, power supply of stk73908 good. Starting resistor(r374 -valor:1m8)aberto.
SHARP C29ST58B
Completely off, just a horizontal luminous streak. Q 3701 tda8350. d 3718 byv95b.
SHARP VC 1094 B
Mad. When plugged in, it goes forwards, backwards, tape does not go into the box. Changing all belts and cleaning the function switch.