Sony Repair Tips
Search: sony
Results: 20088
Results: 20088
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
SONY |
PSX30
|
Detection lever jammed | Scraping noise. cause is detection lever had been jammedunder protrusion on bottom of cam gear in shipping and was permanentlywarped. this was touching the top of the magnet ass'y on the motor shaft. | ||
SONY |
PSX30
|
Incorrect spacing of cam and gear | The gear (reject cam) will not engage. cause is the spacingbetween the cam and the gear on the motor shaft was excessive preventingthe clutch assy to be pushed far enough to engage the teeth. the spacebetween these gears was visibly greater than on oth | ||
SONY |
ICFC11W
|
L8 disconnected | No buzzer alarm. | ||
SONY |
CF520
|
R401 opens | R401 opens and the motor will not run. | ||
SONY |
TCM121
|
Belt jumps off motor | Belt jumps off motor pulley due to lubricant getting on belt. | ||
SONY |
TAE5450
|
Transformer radiating 60hz | Hum in both channels. volume control had very little effecton control of hum. if volume control turned up, tone controls wouldeffect hum. | ||
SONY |
STRV2
|
Blown transistors | Several units came in with blown power fuses. | ||
SONY |
ICF7750W
|
Timer does not function | Timer will not cut off after activating. |