Sony Repair Tips
Search: sony
Results: 20100
Results: 20100
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
KDL 32EX305
|
Turns off and flashes 7 times | Change pci hlr (remote sensor | Smile and deposit something in my accountkkkkk that's the real flaw | cabeça |
| SONY |
LDM3210
MRX1 |
It turns on, there is no image and after a few seconds the screen LED flashes 6 times. | Damaged ry6001 relay. change relay. | pcbots | |
| SONY |
KV29FS100
|
Takes time to call | Circuito mcz 3001d | Mcz3001d | ELETRONICA MAURI JUNIOR |
| SONY |
KLV-32S300A
|
The screen turns on and turns off, remaining in stand bay | Replace sem medir na pci principal f2002 f3001 f4004 f4005 | They give a small replace, in the normal meden test. | ELETRONICA AZEVEDO |
| SONY |
KV-200MQ
|
Arm and disarm before giving an image | Power supply alta 140volts | R618 100k replaced, just replace it. | eletronica reis |
| SONY |
GAME PON
|
Tv sony game pom | When the TV has sound + no image and the standby light flashes without releasing the image. | Check the kinescope board as it may have cold solders or open RGB transistors. because this way the image is not released and remains on the black screen. | Nilson Araujo |
| SONY |
KV-21CL10
BX1 |
Sometimes there is distortion in horizontal deflection | Leak in diode d807 replace with 1n4148 | Divercentro | |
| SONY |
KV1450B
|
No sound | Jap jw 110 | I opened the jap 110 and the TV comes back and the sound works normally | ELETRNICA SANTO ANTONIO .POR / LEDILSON |
| SOM SONY |
HCD-GT-44
|
Eject appears and turns off | Correia do deck | Replace the | Marcondes, jaicós-PI, OHM Eletronica |
| SONY |
FH-33AV
|
Relevant gun but has no sound | Ic 901 and just exchange | NEILDO LIRA | |
| SONY |
KV-21R1E
BE-5 |
Tries to turn it on but it goes down and the LED blinks (goes into protection) | D617 open | Replace diode that is close to t617 | MeA |
| SONY |
KV-2970T
|
Turn on and off | Protection | Swap r655 precision | luciano s dos santos |
| SONY |
MHC-EX6BR_EX8BR
|
When plugging the AC cable into the socket, it goes into protection and does not turn on. | R001 56kΩ alterado | Replace without measuring | deuner |
| SONY |
HCD- DX30
|
Message protect push power. there is no sound and it doesn't work | After trying to turn on a faraoke without success. | ||
| SOM SONY |
GNX 90
|
Does not read the disc | This device uses the ksm 215 unit | Replace unit for a kss 213c or vs original sony and equivalent. | fernando ferreira timbauba PE |
| SONY |
KV-21FX20
FE-1A |
Does not start when cold or loses power | Power supply optocoupler with problems | Replace opto ET1103 | MeA |
| SONY |
KV-2162S
|
No image, normal voltages. | Screen voltage resistor r703(3.3k) open | Replaced the resistor | Alex Mattos |
| SONY |
KV2158
|
Flashing image | Tube triggering protection | I bypassed the tube protection, it was ok | prea |
| SONY |
CDX-GT260
|
Cd fires after stopping does not load the cd | Cd board controller ic | Take 2 1k resistors connect one leg of one with a leg of the other in a 3v3 voltage on the same board and the 2 other legs that are left connect one to the red wire and the other to the white wire that goes to the micro sweet on the part top of the CD mechanism. | ELTON CASTRO embú-sp |
| SONY |
CDX-S2217
|
White display, no characters | D-701 | Get it out now | ELTON CASTRO embú-sp |