Search: sony
Results: 20073
Make Model Symptom Problem Solution By
SONY BE2A
Blank raster - sound ok Scastle pulse dist - dan202 sm diode d504 leaky
SONY BE2/A
Int colour Change the orange coloured colour trimmer ctv 3331 next to the 8.86meg x332 crystal for a green one salvaged from a scrap chassis.
SONY BE2/A
Int col in sympathy with sound - goes off when tapped with eht brushing effect also Check earth pin on loptx for dry joint & loptr heatsink earth conn
SONY BE2/2A
No or int pic C 012 (50v/22uf) near tda3505 and clean pcb underneath.
SONY BE2 KVM1621U
Int pic - comes & goes when banged Dry joints l501
SONY BE2 KVM1410U
Int sound & vis Dry joint l50 next to ic502 tda8304
SONY BE2
St/by only Ps801 cct prot 600ma in ht line o/c
SONY BE2
Squealing psu with sound/pic present C610 22µ 63v
SONY BE2
Int or no col Trimmer in xtal ref osc cct - replace with 22 or 27pf fixed cap
SONY BE2
Int col Dry joints line timebase/psu
SONY BE2
Excess ht of 180v instead of 135v Page 54041
SONY BE2
Dead , volts around str wrong. Check ps801 0.6amp , if o/c check d611 ( r2m ) sony 8-719-303-49 str54041 sony 8-749-901-65
SONY BE2
Dead Ic601 str54041s/c, q601 limiter bc637-16 s/c - when replacing make sure its fitted correctly! check for dry joints esp mains bridge
SONY BE1 KVM2131
Repeatedly blows loptr Dry joints line osc ic551 tda2579a and possibly c808. other possibilities dry joints on line driver tx, loptx & str giving an int high o/p
SONY BE1 KVM19TU
Blank raster turning into line collapse Tda2579a jungle chip was heat sensitive
SONY BE-1
Wont stop on search tune or store Dry joints if can
SONY BE-1
Stuck in st/by Bu506df s/c, ps802 o/c - dry joints ic551 tda2579a tb chip
SONY BE-1
Str54041 destruction Q601 bc637-17, r615 33r o/c- dry joints line osc ic sus
SONY BE-1
No sync Ok without txt panel fitted -o/c track to sm reg tr q02 on txt pcb
SONY BE-1
No control of sound D201 1ss133 or c076 4n7