Search: sony
Results: 20072
Make Model Symptom Problem Solution By
SONY KDL-46R485A
Turns on and off, flashing 6x red LED Panel defect Defective LED bus 2 burnt out LEDs 2.4v LED JORGE TV TÉC PARANA
SONY KLD-46R485A
Turns on normally without antenna or video signal when connecting video signal or antenna it turns off After testing capacitors on the display's v-com, changing the main board gave no results. After jamping the LED bar contacts, the TV was perfect freitas
SONY MHC-EX8BR
Doesn't start, totally dead C302 shorted Replace c302 Carlossbs
SONY LBT-A 495
Sound reading CD showing activity on the display but no sound, even on the power card without audio. R1209, r1259 opened or changed Replace resistors both 100r josé braga
SONY HCD-ZUX9
Panel keyboard does not obey the functions Change the micro keys! or test one for a company to find out which one is shorted! in my case it was the enter key, but I changed everything! Replace the micro keys! Rodrigo vipo
SONY HCD-GTR888
Protect Q4501 altering flasher Replace without measuring Paulo
SONY HCD-E300
Indica "please wait" no cd Clean the connectors of the red cable that takes data from the CD to the board. Persio (TVCompany)
SONY MHC DX 9
It turns on normally but the relay does not arm and tsound is no sound D801 shorted. relay responsible for filtering relay voltage Johicon Silva
SONY KDL-32R305B
Bl turning off in seconds Open LEDs on the buses, be aware that this model turns off in the same way if it is not connected to the t-com, which could cause mistakes if you test it without it. davi.sls
SONY KDL-40EX605
Does not turn on, dead without stand-by 3.3v missing Open resistor r6301 10r, which supplies stand-by IC LUIZ CONSERTOS
SONY 32EX425
Duplicate screen Faulty tcon Homemade method to find out if it is the tcon or screen, we must heat the chip with a blower or if the chip is heating up, use a contact cleaner as a coolant to cool the chip and see if the image returns to normal if it does, it is the tcon if it is not screen pimentelb
SONY STR-K760P
Dead Resistor de 1Ω aberto (r904) Replace and run for the hug Powertech
SONY KDL-40HX755
TV lights up red LED but doesn't turn on, when the power is turned on the green one comes on and goes back to stand by and flashes 3 times Fuse 6002 open and capacitor shorted next to a 3r3 coil. Just replace the shorted capacitor. Ofaztudo - Serra-ES
SONY KDL-32R305B
TV turns on normally but after 10 to 15 minutes it starts to restart. Ci tpc8129. ci smd which is at the power supply input. Replace the IC or place a 1n4007 diode from pin 1 to pin 8 of the IC with the anode on pin 1 and the cathode on pin 8 so that the TV stays on. Gerson Digitecnica
SONY KDL40R485
Turns on and off and the LED flashes 5x Change all the smd ceramic capacitors that are on the 17.5 line on the screen board Replace all the smd ceramic capacitors that are on the 17.5 line on the screen board ALEX LOPES
SONY GTR88
Vu locking and making noise Inside the vu tsound is a seesaw switch with leakage - just change it and it's like new ELISEU
SONY KV-29FS100
Delay in turning on or LED blinking Ci 600 power supply oscillator I just warmed it up with hot air and it works again... good luck Jhone eletronica
SONY 40EX525
It would turn on, it would change from red to green LED quickly, it would not turn on Switch to main board short on bga Switch to main board short on bga rogeriofederal
SONY KV-21FA310
BA-6
Does not turn on, but the relay clicks and blinks 4 times Diode d580 open, put a 1n4148 in place. D580 1n4148 replace. Jadson G Nascimento
SONY 32R435
Turns off and on after 3 minutes sound and image ok Changed led Changing the LED or changing the bar cesila