Search: sony
Results: 20100
Make Model Symptom Problem Solution By
SONY KDL -40EX405
TV doesn't turn on, red LED flashes 3 times Check on main board f3700 3.15a and f4200 5a Replace eletrônica valdecir
SONY KDL-40R485A
The TV blinked 5 times Bad cd26 capacitor on display board. Alan Eletrônica Juca Paulo Afonso Bahia
SONY KLV-37M300A
Turns on and then turns off. stand by LED flashing 5 times. without 12 volts in the t-con power supply. F4005 open on main board. MLTOLOI
SONY KLV-40M400A
Normal image but no audio Shorted capacitors on pins 74 and 75 of the 2002 ic. Removed the same sound arrived normal. ELETRONICA SALES. NATAL RN
SONY KV-29FS110
Turns on, oscillates and turns off LED flashes 4 times. Diodo d647 e d648 In my case I made a replace, I left just one and made a jump on the other Fernando nascimento
SONY KDL-40EX605
Power supply beating relay 12 volts at the foot of the relay ry 601 change the diode I put a 12 volt diode and it was beautiful Israel de Oliveira
SONY GT111Z
Standbay Front plate sweet moth Luiz
SONY KV1440B
White image with retrace Changed resistor Replace resistors 702 and 707 on the kinescope board Roberson
SONY KV1440B
Retrace Changed resistors 702 and 707 on the kinescope board Roberson
SONY KV-29T75
Turning off and with vertical swinging intermittently. In my case it was the vertical ci with a cracked weld. I resoldered the vertical ci and the problem was solved. good luck friends. Giovani
SONY MHC-EX6
Does not turn on Aparace protect en display Cambiar r001= 56kΩ Renatx
SONY MHC-DX70
Protection, press to turn on, turn on and protect Transistor q581 with fault between base and collector I replaced it but it was the same way I tested all the transistors diodes and resistors I decided to remove the stk 412 150 I opened it I tested the transistors inside it two were in short and the other two were leaking I replaced the audio output it was broken Replace stk412 150 and transistor q581 2sc1841 or you can put 2 sc1815 Sebastião rodrigues
SONY MCH-GPX8
Protect e01 Power supply photocouplers Replace the same Oficina dos Eletronicos
SONY KV1450B
Doesn't work Resistor r607 de 150k eletronica zanette
SONY MHC-RG590S
Eject appears and turns off Deck timing defect In my case, I replaced belts, cleaned and lubricated them and it didn't solve the problem. To disable this protection and the deck, disconnect pin 5 cn991 tcm-snyc or remove the resistor from the line FERNANDO JESKE
SONY KDL32BX325
TV doesn't turn on, totally dead. but the power supply has 5.3v from stand by Verified a short between gate and drain of u702 of 5.3v Replacing the hdmi u501 ci which was shorted. replace and go for the hug Ivan Bustamante
SONY MHC-RG111
In the tape function, activate play and the engine stops. everything gets stuck! Micro-switch in parallel with the photo sensor, on the tape PCI, oxidized. Lubricating it and tightening it several times solves the problem! Note, do not use contact cleaner, as almost all of them contain solvent, which destroys the key. bitencourtmaster
SONY MHC-RG111
Turns on, performs functions, but without audio and inoperative mechanism motors! and sometimes it worked normally and then crashed. Smd resistors, in parallel, r427,428,487 and 488, both 2r2 1/8w altered and hot frying, on the regulators supply line, Put one of 0.47r 1w. resolved the defect. bitencourtmaster
SONY KDL-40R485A
Turns on, the red LED lights up, when you press power the LED turns green, you see that the screen lights up but then turns off and flashes error 5 (the red LED flashes 5 times, pauses and flashes 5 times... ) When removing the LED cable from the screen, it continues to flash, when removing the flat that goes to the screen, error 5 continues to flash. This leads us to think that the defect is on the main board, but make no mistake, the defect is on the screen's v-con. shorted smd capacitor Measure the ceramic smd capacitors, in my case it was the cd9, tsound are 04 capacitors close together, but only one shorted MIGUELTV
SONY KLV-32M400A
It turned off after a while and only turned back on after it cooled down. Any sensor related to the TV button control panel Turning off the panel and just using the remote control solves the problem without much hassle Gustavo Sambaquy