Sony Repair Tips
Search: sony
Results: 20077
Results: 20077
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
SPP57
|
No ring/no talk | The handset wouldn't communicate with the base because x-501is oscillating three times its regular speed (ex. 10.5mhz). alsopertains to serial number 41026. | ||
| SONY |
CCDTR101
|
No picture in playback | No video in playback and counter will advance. also unable toturn unit off with cam/vtr switch. i've seen this a couple of times. | ||
| SONY |
CCDFX510
|
Tape jammed | Technician carl smith reports symptom of tape jammed. the setwould sometimes work if tipped on its side. | ||
| SONY |
CCDTR7
|
No zoom - autofocus or iris | Unit initially had no focus or power zoom. when i powereddown and up again, iris would not open either. | ||
| SONY |
SLV393UC
|
Blue screen during playback | Low video level or blue screen on playback of a pre-recordedor self-recorded material. | ||
| SONY |
MZ1
|
Displays "disc error", caused by defective optical device | Unit would display disc error after trying to read toc. rfappeared low-level and distorted. this was a problem with pit discs andgroove discs. | ||
| SONY |
XRU330
|
No cd changer control, all other functions o.k. | All functions worked except cdx-u300 disc changer control. | ||
| SONY |
CCDTR200
|
Dew sensor | Cannot find reference or part number for dew sensor. -hq comments: the dew sensor is part of the flex connector fp-573(1-645-056-12). the dew sensor cannot be ordered separately. | ||
| SONY |
SLV696HF
|
No functions | When unit is initially powered up, drum would run continually. | ||
| SONY |
SLV585HF
|
Gear noise in high speed rewind | When in high speed rewind mode with most of tape on the supplyreel, the gears will intermittently make noise or slip completely causingshut down. | ||
| SONY |
CCDF40
|
Solid blue video on camera e to e | E to e video was solid blue. i traced problem to dt-77board and the dt board had the 28.6363mhz osc (ck in pin 6) into it buthad no clpo, clp1, clp2 or clp3 out. | ||
| SONY |
STRD990
|
No audio - unit in protection | Found 53 volts on both emitter and bass of center channeloutputs. traced back and found high voltages all around q-663. | ||
| SONY |
WMFX40
|
Audio is intermittent | Intermittent audio. | ||
| SONY |
STRAV770X
|
Distortion in surround modes | Considerable amount of distortion in all modes of surround. | ||
| SONY |
TAF500ES
|
Unit in protection | Unit was in protection and found -52 volts across rightchannel outputs. traced problem back to q-451. | ||
| SONY |
CFS2020
|
Former type main board crosses to new type | Service manual 9-953-448-12 lists differences between formerand new type. however,part number of former type main board(a-3260-849-a) subs to part number of new type (a-3260-849-b). servicerneeds former type main board, as new type main board does not f | ||
| SONY |
CCDV99
|
Inoperative unit | Unit came in inoperative. f-62 on the fu-66 board wasoverdiscipated. replacement did not solve problem. | ||
| SONY |
STRD790
|
Unit dead - fuses blow on power up | When unit is powered up, both of-972 and f-971 blow immediately. | ||
| SONY |
CDPC615
|
Dim display | The display was very dim. | ||
| SONY |
DTC700
|
Unit eats tapes - loose tape guides | Customer complained of intermittent rewind and destruction oftapes. found reel motor assembly loose. all three screws had backed outseveral turns. in completing the unit i was checking physical conditionof tape path. found brass posts of entrance and |