Search: sony
Results: 20100
Make Model Symptom Problem Solution By
SONY CCDV5
Replacing lens for ccd-v5 It takes too long to replace lens for the ccd-v5.
SONY CCDV101
Does not record Camera will go to record mode but on playback only black screen. found rf ok at tp-204 but no output on pin 27 or 22 going to drum.
SONY STRGX50ES
Part number for ic-701 The part list in the service manual for ic-701 lists the partfor str-gx60es.
SONY WMAF57
Volume very low Volume very low.
SONY TAM50
Will not record messages After reset, may take one or two messages then will just shut-down.
SONY CCDTR5
No camera record No camera record. line in record ok. viewfinder ok in cameraposition. video out from camera to monitor ok - playback ok.
SONY KV2095R
Intermittent picture blanking, leaky c-317 After unit warms up, picture would be blanked out and comeback ok at approximately one second intervals repeatedly. like a blinking effect.
SONY CCDV5000
Color flickers 30 seconds into playback Color starts flickering after about 30 seconds of playback.
SONY D66
Clv substitute part - motor leads too short A-3133-372-a subs to a-3133-384-a. original motor has eightinch leads. new motor has two inch leads.
SONY CCDTR6
No color record Camera will not record in color - playback ok.
SONY GV300
Ic-101 part number 8-752-816-99 Correct part number 8-752-816-xx. thirty in transit to kansascity parts.
SONY CCDM8U
No record color No color recording from camera section.
SONY CDPC500
Wire harness is too short Regarding service bulletin hfp0127, part number 1-946-072-21yields an eight-pin harness about four inches long, whereas this unitrequires a harness about twelve inches long. -hq comments: will fax tokyo. to tokyo: should harness be longer? isthere a l
SONY SL2000
Very intermittent shutdown in play mode In play mode the unit will shutdown (go to stop mode) veryintermittently.
SONY D10
Static only in audio Static only in audio out.
SONY CDP310
Static with audio Static in audio output.
SONY CCDF35
Alignment manual (camera) On page 221, step 7-2-28 focus motor speed adjustment itsays to go to address 37 set data of 01. change address to 27, obtain 07on the af microcomputer jig and then on step 5. obtain a value of 7.0 +/-.5. what are they talking about? where and how ar
SONY CCDF70
Very shaky picture when recording When recording, capstan motor would have a jittering motion toit. capstan and drum fg was unstable.
SONY KV25XBR
Dead set, replaced thp-601 Set had open line fuse. i could find no shorts. new fuseblows instantly.
SONY HST190
Distortion in tape deck audio Distorted audio on both a and b decks. audio from tuner isok and tape's speed is ok both motors working.