Sony Repair Tips
Search: sony
Results: 20073
Results: 20073
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
KV27EXR10
|
Low volume on variable audio out, normal | We have had several complaints that the volume is too low onthe variable audio output. do you have any official suggestions beforewe fix this problem? -hq comments: this is not defective of the unit. it is just a designsetting. customer can control a | ||
| SONY |
SPP320
|
Intermittent handshake and static on audio | Phone would intermittently not lock up, and when it did, therewas static. when handset was taken apart, phone worked. phone workedbecause antenna was not connected. | ||
| SONY |
STRAV47
|
No audio output-ic501 | Inputs and outputs can be selected but you do not have anyoutput from ic-501, pins 18 and 25. all voltages on ic-501 are goodand have inputs to pin 20, 21 and 22. ic-501 has been changed. -hq comments: i suggest that your problem is caused by either a | ||
| SONY |
CCDF45
|
Does not record | There was no 5v at pin 55 of ic-203 on cv-8 board. thebase of q-210 was 5.1v and would not go to 4.4v. | ||
| SONY |
KV27TS20
|
Vertical foldover in middle of screen, replace r-543 | Unit had foldover in middle of picture vertically. drivewaveform and feedback waveforms were incorrect. r-543 changed value from27kΩ to 35kΩ. resistor is in the feedback circuit. | ||
| SONY |
KV27TX20
|
Snowy picture, c-102 shorted | The picture was extremely snowy on all stations. agc lineread 0v. | ||
| SONY |
KV32XBR10
|
Power switch marking is coming off | Marking on bezel assembly is coming off. other models havethe same problem. | ||
| SONY |
STRAV950
|
Cannot turn on using remote, short between pins 7,8 cnp-822 | When unit is in standby mode, the remote will not turn onthe unit. all other remote functions work, once the unit is on. | ||
| SONY |
CPD1304
|
No blue - cpd monitor | No blue. | ||
| SONY |
CCDF55
|
Part number for eject switch | Servicer orders part number 1-571-275-31 (eject switch)and gets physically incompatible switch. -to tokyo: can you check if this is the correct part number?thank you in advance for your help. -hq comments: correct number is 1-572-284-11. see fpr l1167. | ||
| SONY |
RM788
|
Need service manual for rm788 | Service manual for kpr-46ex20 states that the service manualfor rm-788 will be issued separately. -hq comments: tokyo will not be making a service manual for this remote.if service is needed, the only parts which are available are:1-465-503-11 remote rm | ||
| SONY |
CCDTR5
|
Test connector for ccd-tr5 | Part number for test connector. -to tokyo: is there a part number available for a test connector tomate with cn-204 on the vs-22 board? it may help in servicing theccd-tr5. thank you in advance for you help. -hq comments: this jig should be available | ||
| SONY |
CCDF30
|
Part number for flex connector fp-118 | I need the part number for the flex connector markedfp118 that connects the capstan motor to the ss-86 board. | ||
| SONY |
CDXA30
|
Unit will not play the disc | Will not play disc. found 1.0v dc on negative side of dd1(dc-dc converter). checked for short between outputs and grd all ok.installed new dd1 anyway and tested operation. unit played for 1-2 min.and then dd1 failed again. removed cnj2, cnj1, cnj4, a | ||
| SONY |
GENERAL
|
Soldering in less time | Improvement in soldering technique. | ||
| SONY |
KV8AD20
|
No audio (intermittent no audio) | The unit has no audio, picture is ok. | ||
| SONY |
KV8AD10
|
No audio (intermittent no audio) | The unit has no audio, picture is ok. | ||
| SONY |
CDX7580
|
Intermittent operation | The unit does not work when plugged in or intermittentlyshuts off. the metal used in the connector pins is too soft and does notretain its spring, compromising the connection. in addition, the rearpanel of the sleeve is only attached on the sides, not | ||
| SONY |
TAE1000ESD
|
No p/n listed for the caps that cover the optical inputs | The small plastic covers that are inserted into the opticalinputs when they are not being used do not have a part number. they arenot shown on the exploded view, nor are they listed in the parts list.we have a customer that did not receive them with his | ||
| SONY |
JIGS
|
Availability of extension cables for ld servo checker | Sscs are in need of replacement cables for the ld servochecker (j-6166-370-a) used to service mdp units. currently, we areunaware of any part numbers for these cables. please inform if thesecables have registered part numbers, or if you plan to registe |