☰

Sony Repair Tips




AIWA
BEKO
CCE
CINERAL
DAEWOO
FUNAI
GRADIENTE
GRUNDIG
HITACHI
ITT
JVC
LG
MITSUBISHI
PANASONIC
PHILCO
PHILIPS
PIONEER
RCA
SAMSUNG
SANYO
SHARP
SONY
THOMSON
TOSHIBA
VESTEL


Search: sony
Results: 20100
Make Model Symptom Problem Solution By
SONY AVU270
Unit stays in stand-by Unit will not power up.
SONY CDP310
Chucking arm broken When disc loaded for play, unit is very noisy.
SONY CCDV8AFU
Dark camera picture Dark camera picture when unit cold, after warm up unit played.
SONY AVU270
Surround sound level low on tv only Only saw a noticeable level change when unit on tv surround.all other functions of surround sound good.
SONY KV2786R
P in p height adjustment, no adjustment exist When viewing a program which has lettering on the screen ontop or bottom, the picture on the main screen will be ok. but the p-pportion will cut off the lettering. is there a height adjustment whichcan be done only on the picture in picture section? -
SONY D55
Fm distortion Customer (radio station general mgr.) complained that fmsounded fuzzy and distorted on this unit. verified problem by usingsoundtechnology st1000 generator. we observed waveform by going tostereo and l+r modulation.
SONY CDP35
Static in audio only when music is playing Unit makes ticking sound at audio output only when music isplaying. in pause, ff or rev track jumps, all is quiet. unit set upperfectly. ticking sound was at same volume as information at output.
SONY KPRM360
Blown fuses - muted picture The first time in the unit had a bad ic6008 and cp6005 andcp6006. now 3 weeks later just the fuses were open. because of theprevious problems i have had with the fuses in these circuits, i increasedthe fused from 0.8 amp to 1 amp. the shop will inform
SONY KV1513
Excessive hv - shut down This unit had hv at 29kv. the unit would run for one halfhour to one hour, and then shut down. the fbt was found to have a brokenu clamp.
SONY CFD5
Error in schematic and/or block diagram In blk diagram (page 25-26) ams ic is declared as ic103.schematic (page 69) calls it ic303 and then ic353 on chip block itself.both ic303 and ic353 are listed in parts list. what is correct p/n?
SONY SL2710
Slight horizontal jitter in top of picture Unit displayed slight jitter in top of picture when playingpre-recorded tapes. self record ok. slowing down head drum with fingerimproved picture. drum free run adj. had no effect on jitter. replacingupper drum had no effect.
SONY KV1972R
Radio interference, see sb ctv0288r Picture remains free of interference but sound is picking upthe transmission. even with unit turned off, sound is still there.customer has an amateur radio station.
SONY KV2782R
Crt cracked, replace d-505 and crt Crt with neck cracked inside the yoke area. prior to connect-ing the chassis to new crt, the set was operated ok on the bench jig. hvmeasured 24kv. in second set, anode voltage measured 28 to 29kv. picturedisplayed severe pin cushion distortion. fou
SONY GENERAL
Kcp parts Due to design of 27 consoles, controls mounted on bezel.this necessitates pulling cabinets. my suggestion: make jig available tosubstitute controls saving labor to pull unit. -hq comments: crt jig is available now. please contact telematic (718-271-52
SONY XR70
Incorrect ref. # - page 26; ref. #60 Ref. number wrong. page 26 (ref. #60) is showing a cable(with connector). the cable (with connector) is ref. #751-555-488-00. -hq comments: we will issue a service bulletin.
SONY CCDV110
No viewfinder characters display This unit had no character display in the viewfinder. thecharacter generator ic was found to be defective. the on tape characterswere ok.
SONY KV2781R
Dead, replace r-555, d-557 and crt The neck of the tube in this unit and a continuous arcing.this was the probable cause of the shorting of d557 and the opening ofr555.
SONY FD45A
Manual correction, crt p/n 8736-853-05 Part number in manual does not exist according to kansas city,part number listed is 8-736-853-01. should have been 8-736-853-05.this is a crt, ref # v901 listed on page 31. -hq comments: we sent information to japan, will issue a s/b about this.
SONY WMF100
One channel out on tape function One channel had no output in one direction.
SONY CCDM8U
Servo circuits dead Three units with same problem in ssc. you could load tape in and it would thread up but unit would do nothing else after this other than turn on/off.