Sony Repair Tips
Search: sony
Results: 20072
Results: 20072
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
SONY |
KV2670R
|
Improper brightness, r-526 and d-508 | Brightness and screen controls did not work. | ||
SONY |
STRVX750
|
Audio cuts out | After unit warms up, sp relay kicks off. | ||
SONY |
KV2681R
|
Dead, replace t-501 and q-504 | Unit was dead due to one leg of t501 was shorted to groundwhich in turn took out the h. output transistor. | ||
SONY |
KV2680R
|
Raster but no audio/video, ic1109 shorted on "x" board | Unit had raster out, no video nor audio, and r1247 wouldshort out at turn on. | ||
SONY |
KV25XBR
|
Marginal failure of ic651 regulator module | Dark pix (customer complained of no video, however video isdiscernable when pix contrast is maximum), 90% raster (horizontal width),audio ok. | ||
SONY |
PSLX510
|
Incorrect ass'y number | Could not locate part number for stator assy. found on page27 the assembly is numbered 129. it should be 126. -hq comments: will issue a t/n and s/b. | ||
SONY |
XRM10
|
Very low, yet undistorted am band audio level | Audio ok coming out of am ic, but would not pass thru c-60 onam pc board. | ||
SONY |
CFSF11
|
No record | Pause is engaged before record. indicator lights but recordlinkage is not engaged. the record trigger lever is jarred off recordlever a (see p.10 of the supplement #1). -hq comments: replacement of forward lever is necessary. the problemcomes from th | ||
SONY |
SL25
|
No p/b or f/f functions | No f/f mode at all. would enter rewind mode whenever the p/bmode was entered. the sensor leads resistance would change from 4Ω to20Ω whenever the leads or the pc bd of the sensor was agitated. | ||
SONY |
KX2501A
|
All blue raster, retrace lines, very low video level, q1302 | Crt raster was all blue with faint retrace lines and very lowvideo level. we were unable to reduce the blue level with crt or bright-ness controls. dc voltage checks allowed me to trace problem to a leakytransistor, q1302 on bd board. | ||
SONY |
KP4600B
|
No green vertical sweep | With set on, there was no green and display bar (which wasblack), rolling vertically. system looks like a problem in the picturetube area, but found no green vertical sweep. with loss of verticalsweep, there is no horizontal line, because itclue was th | ||
SONY |
SLHF300
|
No power | Unit would not power up. replaced ic301 (timer) but ic wouldnot reset, so problem was not resolved. | ||
SONY |
D5
|
Blown transistors and ic (sled circuit) | Unit was brought in for service due to defective sled motorgears. upon inspection, we discovered that ic508 and q502-505 were burntseverely. the chip transistors disintegrated. ic508 is cracked and brownin color. | ||
SONY |
BMC550
|
Incorrect p/n page 148 | Typo in manual, page 148. -hq comments: correct p/n sk-3 board (complete) a-7060-078-a ds-10 board (complete) a-7060-098-a ds-10 board part number is correct on page 175 in the s/m. | ||
SONY |
KV2602
|
Only tunes low channels, replaced non sony q008 | Vc voltage at tuner would only go up to 10vdc. | ||
SONY |
TCFX505R
|
Controller chips difference | When ordering ic501 and ic505, tc #9310n-032 (8-759-201-86)and tc #9310n-033 are sent instead of -021 and -022. the serial # showsthe unit falling into the former type but icalso fiche crosses to the new numbers. are the two compatible? -hq comments: | ||
SONY |
KV2680R
|
Audio exists at vol zero, replace ic-1107 | When the audio level is turned all the way down, you can still hear audio. | ||
SONY |
BMC550
|
Replacement numbers for cr2025 battery | Since we do not have sample cr2025 battery, can you advise theduracell or eveready replacement numbers? -hq comments: the numbers are as follows: sanyo cr2025 duracell dl2025 | ||
SONY |
KV1515
|
No high voltage | No high voltage, +115v up to +142v. half of the dialindicators light at the same time. sometimes the tv would work normal. | ||
SONY |
KP5040
|
Cable interference, soldered tuner, prescaler and ant sw | Fine diagonal lines on ch. 4 spaced about one inch apart. |