Sony Repair Tips
Search: sony
Results: 20072
Results: 20072
| Make | Model | Symptom | Problem | Solution | By |
|---|---|---|---|---|---|
| SONY |
SL2001
|
Unit will not go into play mode | Unit would load, thread tape, ff/rw, but the pinch solenoidwould engage, therefore i had no pb mode. when i checked to see if thecam switch was open by connecting myΩ meter across it while i pressedplay, the unit worked. this was due to the cam sw c | ||
| SONY |
SLHF300
|
No part number for fu-21 board | Need part number for fu-21 board complete. -hq comments: complete part number for the fu-21 board is a-6716-351-a.part numbers assocated with the board can be found in the s/m correction# 3 p/n 9-972-316-93. | ||
| SONY |
SL5200
|
New fs-27 board | The new pc board is different than the old board for themounting of the auto sw s001. the old board has eight mounting holes ina row. the new board for the mounting of the auto sw s001 has twovertical rows of six holes each. how does the auto sw s001 | ||
| SONY |
SL2500
|
Tape spilling | In the playback mode the take-up reel was not taking the tapeand the tape was spilling out at the pinch roller. the cassette waslocked in the cassette compartment. | ||
| SONY |
KV1357R
|
Dark picture, replaced c-556 | R557 opens up within seconds (because of shorted c-556). | ||
| SONY |
STJX4
|
No output | Q601 overheating. collector of q601 2vp-p of a.c. ripple. | ||
| SONY |
D5
|
Defective upc | Unit only plays track 16 of disc. | ||
| SONY |
SL2300
|
Video heads too tight | In order to remove the head for replacement, one must usemuch force as the mechanical fit is too tight. the servicer has had twoin the last 2 months. one new head was defective and the parts dept. didnot want to exchange it as it was all scratched up. | ||
| SONY |
SLHF300
|
Left ch distortion on beta hifi playback only | Left channel distortion on beta hifi playback only caused byam radio station 1540 khz. | ||
| SONY |
KV2680R
|
No functions except power on, ic-103 | No remote control functions, no channel change, volume change,color change or any control available at the receiver manually exceptpower on. | ||
| SONY |
ICF7600A
|
Intermittent shortwave/fm only with back cover on | Technician placed unit on tech assistance sheet for the condition of intermittent shortage/fm only. problem only happen with back cover on and while squeezing back cover. | ||
| SONY |
SL2300
|
Repeated failures of ic1 on rp-8 board | Loss of alternate video fields from heads. discovered ic-1channel a not passing signal. | ||
| SONY |
D5
|
Distorted audio | This unit had distorted audio in both channels. | ||
| SONY |
TCU30
|
Missing part # for lever assy, eject | There is no part # for lever assy, eject. -hq comments: the part number for the eject lever is x-3565-501-0. | ||
| SONY |
CRF330R
|
Missing part # for panel front | No part # for panel, front. -hq comments: the part number is 3-880-501-11, but it is no longeravailable from npc nor tokyo. | ||
| SONY |
KV1770R
|
Poor purity | The screen had a strange green hazel color to it. it appearedlike a chroma problem but a little experimenting revealed a problem withthe crt. it was not possible to achieve anything close to correct purity. | ||
| SONY |
KV2680R
|
No audio/video, replace 15v reg drive q-1128 | Unit had raster out no video or audio. | ||
| SONY |
KV2670R
|
Will not turn on manually, replace ic-105 | Unit would turn off and on with remote control but notmanually. | ||
| SONY |
TCFX44
|
Motor boating during record | Unit motorboats intermittently during record, putting soundon tape. | ||
| SONY |
SL2400
|
Record/ee picture distorted | Problem looked like tuner agc problem. playback ok. pin 5ic4 had 5.3v. found no adjustment of rv2 (peak agc). base of q4 was 6.3vand could not adjust. measured resistance of voltage divider, found thisto be 28k. checked voltage r22 found no voltage |