Search: sony
Results: 20100
Make Model Symptom Problem Solution By
SONY KV1952RX
No raster, no volume, no channel display, replace q2002 No raster at turn on. raster may be seen for 1/2 second. novolume, no channel display, b+ present, high voltage present.
SONY TCK777
Part # of the relay A tech ordered ry501 by the part # 1-515-323-21 listed inthe service manual. but it seems that it is not registered in thecomputer. this is a part # 1-515-323-00 in the computer. i think theyare same. we are going to try to order 1-515-323-00.
SONY TC60A
Replacement motor A customer ordered the motor (d-011g, p/n 8-834-011-00) andhe received the replacement motor (dnm-2400a, p/n 8-835-016-01). thereplacement motor turns backward, and if he reverses the polarity of thewires, he said the unit makes motor noise. he brought
SONY AIR8
Replacing ic301 It is impossible to replace the microprocessor ic301 on thekey sw board without damaging the pattern of the pc board. ic301 is 64pin fat package ic and there is the silicone compound on the pins. also,i noticed the pins are relatively fatter than the p
SONY D5
Failure of sled motor gear ass Units are not functional, fop jammed. found gear assy on allthree units with broken teeth.
SONY CFS9000
Broken gear of head bracket ass The gear seems so hard. it is easily broken.
SONY KV2645R
Thump in audio when channel changed, replaced c226 Two kv-2645rand static in audio. the thump was kind of twang or dampered osc to it.
SONY CDP101
Distorted left output Distorted left output.
SONY STRVX200
Loss of memory after shut off Loss of memory after shut off. after shut off the batteryback up voltage was loaded down to 1.1v. unit had a reset timing problem.changed d302 from a eqa01-19rv to a eqa01-17rv. 19 zener to 17 zener.pin 33 (ic301) is labelled stereo mono, should be cp
SONY XO5
Shut off The unit shuts off in any mode. the tech. replaced q803 andq805, but still it did not have a pulse at pin 11 of ic801.
SONY EBP9LC
No recharge - np11 A customer complained that his ebp-9lc for the d-5 does notrecharge the np-11.
SONY PSX800
Irregular horizontal motion of the tonearm The unit came in a service station second time. first time,the tonearm did not go down intermittently. we went through the electricadjustment. the unit worked fine. couple of month later, the unit camein for same problem.
SONY CFM100
Breakage of deck chassis Back on groove for lock plate #363 in manual is not completeall the way across deck. when rew lever is pushed down, it forces locklever against side of groove breaking plastic groove and bending locklever. only solution to this is to change chassis #37
SONY STRVX550
No remote function No remote control operation. reset controller ic301, did notrepair problem.
SONY SL5000
Threading belt slippage causing loading and eject failure Failure to load or unload tape.
SONY SLHFR30
Much grainier and darker picture Picture is much grainier and darker than his tv when on cable.this e to e or playback can -hq comments: we have not received any similar reports regarding thisproblem. i checked in our lab with an hfr30 connected to an antennasystem, and also at home c
SONY SL5200
Intmt partial threading and loading operation at turn on Intermittently, at turn on, unit would partically load andthreading ring would rotate about 1/4 turn and everything would stop.then when you shut unit off and turn it on again it would return threadingring to start position as well as the cassette compar
SONY KV1920
Severe tearing in pix both horiz and vert - poor interlace Picture had severe tearing and poor interlace. scoping agcbuss revealed high noise level.
SONY SL2710
No beta hifi indication in e to e or no beta hifi record Unit displayed no beta hifi indication in e to e mode andwould not record beta hifi. beta hifi playback was ok. found no 9vavailable from switch on pk-3 board due to shorted capacitor c568.
SONY SL2000
Unit will not record but p/b ok Unit would not record due to very low record current. therewas no voltage present at pin 8, ic3.