Sony Repair Tips
Search: sony
Results: 20072
Results: 20072
Make | Model | Symptom | Problem | Solution | By |
---|---|---|---|---|---|
SONY |
KP5040
|
Incorrect mechanical function, use of loctite | When unit was turned on the mirror door would extend about2/3 of the way out and start clicking. the motor would continue to runand not shut off. disassembly revealed the retaining nut on the driveshaft had worked loose allowing the left hand side door | ||
SONY |
KV2647R
|
No picture, open r057 and prescaler, | R057 resistor open (mf board). no problem found in reg.circuit. solder splash on feed thru terminal of prescaler. | ||
SONY |
KV2645RS
|
Tuning would not lock, replaced s2262 | Tv would continuously scan through all channels. foundchannel up button closed. | ||
SONY |
KV2645R
|
Dark picture, replaced r-751 | Dark picture like weak crt. found r751 changed value. | ||
SONY |
KV2601
|
Part number missing | Servicer has kv-2601 with spark gap on c board shorted -schematic designation sg. the part number was omitted from the servicemanual of all the above listed models. -hq comments: the spark gap in question is not available as a separatepart. it comes w | ||
SONY |
KV1945RS
|
Picture distortion, replaced c544 | Severe pincushion problem, pin control has no control. baseof q503 was negative instead of 2v. found signal on base has a lot ofspikes, which could come only from one point, the flyback. c544 was opencausing no filtering. | ||
SONY |
KV1945R
|
No picture, replaced shorted q006 and q008 on md board | This set had no vc voltage and band selection voltages werewrong at tuner. | ||
SONY |
KV1945R
|
Shut down, trimmed r563 | This unit intermittently shuts off by itself. | ||
SONY |
KV1913
|
Picture distortion | These two units came in with high brightness with retracelines. found r721 open. | ||
SONY |
KV1543R
|
Intermittent remote operation, replaced c005 | Remote commander operative only about 10% of time, mostfunctions completely inoperative. with scope probe at tp 52 m-2 boardabout 5vpp random noise present and remote control signal distortedwhen actuated. | ||
SONY |
KP5000
|
Picture distortion, loose screw on hor drive trans. q5104 | Intermittent horizontal sweep problem causes sweep to collapseand burn a vertical line in the three picture tubes. | ||
SONY |
KV2648R
|
Snow picture, replaced prescaler | Picture would go to snow after about 5 minutes after turn-on.set was ok when cold. 12 volt line would drop to 7.5v and voltage atprescaler would drop to 1.5v. | ||
SONY |
KV2648R
|
High pitch noise | The unit makes a high pitch sound like a flyback with loosecore. replacing pot transformer did help a little but still audible.wedging the transformer almost reduce noise but awkward solution. | ||
SONY |
KV2647R
|
Tuning drift, resolder r053 | Upon changing channels a good video will come on for a momentbut will drift off to barely viewable negative picture. | ||
SONY |
KV2647R
|
No control of brightness, broken foil on crt board | No control of brightness. picture would start at normallevel and slowly get dimmer with retrace lines, then flash to normalpicture level again. no g2 voltage on pin 12 of crt board. | ||
SONY |
KV2647R
|
Picture distortion, replace c549, c550 and c554 | Slight pie crusting and marginal horizontal sync. | ||
SONY |
KV2645R
|
No remote operation, repaired crack on n board | Unable to control operation with remote. found hairlinebreak on n board. | ||
SONY |
KV2643R
|
Under scanned picture, r533 value changed, replaced | Picture under scanned horizontally and vertically. foundresistor r533 changed value, should read 1.2Ω, read 14Ω. | ||
SONY |
KV2602
|
Vertical foldover, replaced ic502 | Vertical foldover at bottom. all voltages around ic501 andic502 checked good except pin 5 of ic502 which was very low, waveformswere distorted. | ||
SONY |
KV2145R
|
No video/sound, replaced prescaler | No video - no sound. |