Toshiba Repair Tips

Search: toshiba
Results: 5592

Make	Model	Symptom	Problem	Solution	By
TOSHIBA	TV 2089 U14	Doesn't work av	Ic micro eq. 8843cpng4v47		assis
TOSHIBA	TV-2999JMS	The alloy has no brightness, it increases all the brightness and contrast in the menu and nothing, it appears to be a tube. measure the screen if it gives 150v and the screen does not darken when measuring, change the 1k c902 on the tube plate, put 4k7	I changed it and it was wonderful.		Eronaldo
TOSHIBA	TV 1449M ,TV1470, TV2070 ,TV 2055	Switching channels directly	Change touch key ch - and ch+		Marcio Magalhães
TOSHIBA	TV 1449M	Open fuse inoperative	Replace q 804 2sc 3831 e fusivel		Marcio Magalhães
SEMP TOSHIBA	U16 U16	Flashing color(agc?)	C216 change without measuring. change r216 to 100k		Moyses Machado
TOSHIBA	1495 KM	The channel runs away	Cold welds, resolder inside the varicape
TOSHIBA	TV2090AV U14	Turns on, the stand-by LED lights up and the TV takes a while to start.	C419 of 47x50 with little capacity.	Replace.	nachbar
SEMP TOSHIBA	TV1480	The television had no image and no sound, the horizontal stage did not oscillate, the 9 volts on pin 21 of IC 501 were cut off. The power supply was normal, it turned on and off normally.	Shorted deflector coil. I replaced the deflector coil, and the TV worked.		Eletrônica LM
TOSHIBA	MS6610CD	No sound, there was only sound on the headphone output.	The stk402-070 was ok, the smd bd3872 was ok, after testing a lot I arrived at the c3200 transistor that had a problem.	Just put another one in its place. q908 - c3200. If you don't have the same one, you can put the c2655 or c3209, both are npn.	ELETRONICA SÃO FRANCISCO - BARRAS - PI
SEMP TOSHIBA	TV 2121 NFS U 18	It turned on the standbay and turned it off until it reached m+ b	Swap str 5453 roco sound q 906		ELETRONICA IDEAL
TOSHIBA	TV2998EMS LEM 2	Lines, interference on the screen even in av	C 213 0,47 / 50v no pino 39 do ci tb1254n		betoteck
TOSHIBA	TV-1483FAV U11	With normal audio but with lines of retraces	Open 12k r447	Replaced it was ok	salvino
TOSHIBA	TV 2090-I AV U-14 *	I turned it on and quoted it later and +b dropped to 5v and a normal power supply	D-302 ic-301	To replace	wagner
TOSHIBA	29 LEM 7	Hoarse sound and bluish image	Smd transistor on the PCI of the tube with a leak passing 1.2 volts where there should be 0 volts.	Replace q907	eletronica fernandes
TOSHIBA	TV 2091 U14 R	Blue screen without sound remove screen without sound. image	Q 109 em s m d pnp		javan
TOSHIBA	U14R	Burning q404 bu808	Replace c419 47/50 d448 e d449 ok?		JUVENAL PICOS-PI
SEMP TOSHIBA	TV2070E	Image closing the sides and folding	T803 open		Roque
TOSHIBA	TV20A82 U8	+b 113 low	The tv doesn't oscillate	C-448	mi_fabbi
TOSHIBA	LEM4 LEM4	This Toshiba 2998gms came into the workshop with vertical problems and the color blue predominating. these problems were easily repaired. After it was ready, when turning it off using the control, there would be a horizontal strip on the screen, as if the vertical had been closed, for about 5 seconds and little by little it would go out. If it was turned off by the main switch this would not happen.	The problem was in power/h-vcc. resistor r841 (5k6 x 1/6w) open.		Paulorusso
TOSHIBA	2050MAV U17	Vertical closed three fingers bottom of the screen	R421		gillopes